ONKYO TX-SA705 Manual Do Utilizador

77

Advanced Setup—Continued

Some of the settings in this section are set automatically 
by the Automatic Speaker Setup function (see page 54).
Here you can check the settings made by the Automatic 
Speaker Setup function, or set them manually, which is 
useful if you change one of the connected speakers after 
using the Automatic Speaker Setup function.

Note:
The Speaker Setup cannot be carried out while head-
phones are connected to the AV receiver/AV amplifier. 

See “Speaker Settings” on page 46.

With these settings, you can specify which speakers are 
connected and a crossover frequency for each speaker.

The following crossover frequencies can be specified: 
Full Band, 40 Hz, 50 Hz, 60 Hz, 70 Hz, 80 Hz (THX), 
90 Hz, 100 Hz, 120 Hz, 150 Hz, or 200 Hz.
Specify Full Band for speakers that can output low-fre-
quency bass sounds adequately, for example, speakers 
with a good sized woofer. For smaller speakers, specify 
a crossover frequency. Sounds below the crossover fre-
quency will be output by the subwoofer instead of the 
speaker. Refer to your speaker’s manuals to determine 
the optimum crossover frequencies.

Please note that any THX main speakers should be set to 
Small [80 Hz (THX)]. If you set up your speakers using 
the Automatic Speaker Setup function, please make sure 
manually that any THX speakers are set to Small with 
80 Hz (THX) crossover.

This setting is set automatically by the Automatic 
Speaker Setup function (see page 54).

Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.

buttons to select “2. Speaker 
Setup,” and then press [ENTER].
The Speaker Setup menu appears.

buttons to select “2. Speaker 
Config,” and then press [ENTER].
The Speaker Config menu appears.

Yes: Select if a subwoofer is con-

nected.

No: Select if no subwoofer is con-

nected.