ONKYO HT-RC460 Manual Do Utilizador

The speaker terminals are color-coded for identification 
purpose.

The supplied speaker cable labels are also color-coded and 
you should attach them to the positive (+) side of each 
speaker cable in accordance with the table above. Then all 
you need to do is to match the color of each label to the 
corresponding speaker terminal.

Read the following before connecting your speakers:
• You can connect speakers with an impedance of between 

6 and 16 ohms. If you use speakers with a lower 
impedance, and use the amplifier at high volume levels 
for a long period of time, the built-in amp protection 
circuit may be activated.

• Disconnect the power cord from the wall outlet before 

making any connections.

• Read the instructions supplied with your speakers.
• Pay close attention to speaker wiring polarity. In other 

words, connect positive (+) terminals only to positive (+) 
terminals, and negative (–) terminals only to negative (–) 
terminals. If you get them the wrong way around, the 
sound will be out of phase and will sound unnatural.

• Unnecessarily long, or very thin speaker cables may 

affect the sound quality and should be avoided.

• Be careful not to short the positive and negative wires. 

Doing so may damage the AV receiver.

• Make sure the metal core of the wire does not have 

contact with the AV receiver’s rear panel. Doing so may 
damage the AV receiver.

• Don’t connect more than one cable to each speaker 

terminal. Doing so may damage the AV receiver.

• Don’t connect one speaker to several terminals.

Front left, Front high left, Zone 2 left

White

Front right, Front high right, Zone 2 right

Red

Center

Green

Surround left

Blue

Surround right

Gray

Surround back left

Brown

Surround back right

Tan