ONKYO HT-R368 Manual Do Utilizador

1. Recording Copyright—Unless it’s for personal use 

only, recording copyrighted material is illegal without 
the permission of the copyright holder.

2. AC Fuse—The AC fuse inside the unit is not user-

serviceable. If you cannot turn on the unit, contact your 
Onkyo dealer.

3. Care—Occasionally you should dust the unit all over 

with a soft cloth. For stubborn stains, use a soft cloth 
dampened with a weak solution of mild detergent and 
water. Dry the unit immediately afterwards with a 
clean cloth. Don’t use abrasive cloths, thinners, 
alcohol, or other chemical solvents, because they may 
damage the finish or remove the panel lettering.

WARNING
BEFORE PLUGGING IN THE UNIT FOR THE 
FIRST TIME, READ THE FOLLOWING SECTION 
CAREFULLY.
AC outlet voltages vary from country to country. Make 
sure that the voltage in your area meets the voltage 
requirements printed on the unit’s rear panel (e.g., AC 
230 V, 50 Hz or AC 120 V, 60 Hz).

The power cord plug is used to disconnect this unit 
from the AC power source. Make sure that the plug is 
readily operable (easily accessible) at all times.

For models with [POWER] button, or with both 
[POWER] and [ON/STANDBY] buttons:
Pressing the [POWER] button to select OFF mode 
does not fully disconnect from the mains. If you do not 
intend to use the unit for an extended period, remove 
the power cord from the AC outlet.

For models with [ON/STANDBY] button only:
Pressing the [ON/STANDBY] button to select 
Standby mode does not fully disconnect from the 
mains. If you do not intend to use the unit for an 
extended period, remove the power cord from the AC 
outlet.

Caution
Excessive sound pressure from earphones and 
headphones can cause hearing loss.

Warning
Batteries (battery pack or batteries installed) shall not 
be exposed to excessive heat as sunshine, fire or the 
like.

7. Never Touch this Unit with Wet Hands—Never 

handle this unit or its power cord while your hands are 
wet or damp. If water or any other liquid gets inside 
this unit, have it checked by your Onkyo dealer.

8. Handling Notes 

• If you need to transport this unit, use the original 

packaging to pack it how it was when you originally 
bought it.

• Do not leave rubber or plastic items on this unit for a 

long time, because they may leave marks on the 
case.

• This unit’s top and rear panels may get warm after 

prolonged use. This is normal.

• If you do not use this unit for a long time, it may not 

work properly the next time you turn it on, so be sure 
to use it occasionally.

Replacement and mounting of an AC plug on the power 
supply cord of this unit should be performed only by 
qualified service personnel.

The wires in the mains lead are coloured in accordance 
with the following code:

Blue: Neutral

Brown: Live

As the colours of the wires in the mains lead of this 
apparatus may not correspond with the coloured markings 
identifying the terminals in your plug, proceed as follows:

The wire which is coloured blue must be connected to the 
terminal which is marked with the letter N or coloured 
black.
The wire which is coloured brown must be connected to 
the terminal which is marked with the letter L or coloured 
red.

The plug is fitted with an appropriate fuse. If the fuse needs 
to be replaced, the replacement fuse must approved by 
ASTA or BSI to BS1362 and have the same ampere rating 
as that indicated on the plug. Check for the ASTA mark or 
the BSI mark on the body of the fuse.
If the power cord’s plug is not suitable for your socket 
outlets, cut it off and fit a suitable plug. Fit a suitable fuse 
in the plug.

Declaration  of  Conformity

We, ONKYO EUROPE

ELECTRONICS GmbH
LIEGNITZERSTRASSE 6, 
82194 GROEBENZELL, 
GERMANY

GROEBENZELL, GERMANY

ONKYO EUROPE ELECTRONICS GmbH

K. MIYAGI

declare in own responsibility, that the ONKYO product 
described in this instruction manual is in compliance with the 
corresponding  technical standards such as EN60065, 
EN55013, EN55020 and EN61000-3-2, -3-3.