ONKYO HT-R368 Manual Do Utilizador

Here you can adjust the level of each speaker with the 
built-in test tone so that the volume of each speaker is the 
same at the listening position.

• These settings cannot be calibrated in either of the following 

cases:
– A pair of headphones is connected.
– The  “Audio TV Out” setting is set to “On” (

– “HDMI Ctrl (RIHD)” is set to “On” (

) and you’re 

listening through your TV speakers.

– Speakers B is on.
– Speakers A is off.
– The AV receiver is muted.

■

, Right, Surround Right, Surround 

`

–12 dB to 0 dB to +12 dB in 1 dB step.

■

`

–15 dB to +3 dB to +12 dB in 1 dB step.

• Speakers that you set to “No” or “None” in the “Sp Config 

) cannot be selected.

*1

For the center speaker and subwoofer, the level settings made 
by using the Home menu are saved in this menu (

• If you’re using a handheld sound level meter, adjust the level of 

each speaker so that it reads 75 dB SPL at the listening position, 
measured with C-weighting and slow reading.

With the Audio Adjust functions and settings, you can 
adjust the sound and listening modes as you like.

■

`

Main 

`

`

This setting determines which channel of a stereo 
multiplex source is output. Use it to select audio channels 
or languages with multiplex sources, multilingual TV 
broadcasts, and so on.

■

`

Left + Right 

`

`

This setting specifies the channel to be used for playing 
any 2-channel digital source such as Dolby Digital, or 2-
channel analog/PCM source in the Mono listening mode.

■

These settings apply to only 2-channel stereo sources.

`

`

Off 

With this setting, you can broaden the width of the front 
stereo image when using the Dolby Pro Logic II Music 
listening mode.

`

–3 to 0 to +3

With this setting, you can move the sound field forward or 
backward when using the Dolby Pro Logic II Music 
listening mode. Higher settings move the sound field 
backward. Lower settings move it forward.
If the stereo image feels too wide, or there’s too much 
surround sound, move the sound field forward to improve 
the balance. Conversely, if the stereo image feels like it’s 
in mono, or there’s not enough surround sound, move it 
backward.

`

0 to 3 to 7

With this setting, you can adjust the width of the sound 
from the center speaker when using the Dolby Pro Logic II 
Music listening mode. Normally, if you’re using a center 
speaker, the center channel sound is output from only the 
center speaker. (If you’re not using a center speaker, the 
center channel sound will be distributed to the front left 
and right speakers to create a phantom center). This setting 
controls the front left, right, and center mix, allowing you 
to adjust the weight of the center channel sound.