ONKYO TXNR525 Manual Do Utilizador

■

■

When tuned into an RDS station, the RDS indicator 
lights. 
When the station is broadcasting text information, the 
text can be displayed.

■

RDS stands for Radio Data System and is a method of 
transmitting data in FM radio signals. It was developed 
by the European Broadcasting Union (EBU) and is 
available in most European countries. Many FM 
stations use it these days. In addition to displaying text 
information, RDS can also help you find radio stations 
by type (e.g., news, sport, rock, etc.). 

The AV receiver supports four types of RDS 
information:
PS (Program Service)
When tuned to an RDS station that’s broadcasting PS 
information, the station’s name will be displayed. 
Pressing DISPLAY will display the frequency for 3 
seconds.
RT (Radio Text)
When tuned to an RDS station that’s broadcasting 
text information, the text will be shown on the AV 
receiver’s display. 
PTY (Program Type)
This allows you to search for RDS radio stations by 
type. 
TP (Traffic Program)
This allows you to search for RDS radio stations that 
broadcast traffic information (

• RDS works only in areas where RDS broadcasts are 

available.

• In some cases, the text characters displayed on the AV 

receiver may not be identical to those broadcast by the 
radio station. Also, unexpected characters may be 
displayed when unsupported characters are received. This 
is not a malfunction.

• If the signal from an RDS station is weak, RDS data may be 

displayed intermittently or not at all.

■

■

You can search for radio stations by type.

Press MEMORY again to store the station or 
channel.
The station or channel is stored and the preset 
number stops flashing.
Repeat this procedure for all of your favorite 
AM/FM radio stations.

e/r on the AV 

• You can also use the remote controller’s number 

buttons to select a preset directly.

Select the preset that you want to delete.
See the previous section.

While holding down MEMORY, press TUNING 
MODE.
The preset is deleted and its number disappears 
from the AV receiver’s display.

Press RT/PTY/TP once.
The RT information scrolls across the AV 
receiver’s display.

• The message “Waiting” may appear while the AV 

receiver waits for the RT information.

• If the message “No Text Data” appears, no RT 

information is available.

Press RT/PTY/TP twice.
The current program type appears on the AV 
receiver’s display.

e/r to select the type of 

program you want.
See the table shown later in this chapter.

To start the search, press ENTER.
The AV receiver searches until it finds a station of 
the type you specified, at which point it stops 
briefly before continuing with the search.