ONKYO HT-R640 Manual Do Utilizador

36

With 

 (Remote Interactive), you can use the follow-

ing special functions:

■

When you start playback on a component connected 
via 

, if the AV receiver is on Standby, it will 

automatically turn on and select that component as 
the input source. Similarly, when the AV receiver is 
set to Standby, all components connected via 

 

will also go on Standby. This function will not work 
on components connected to an AC OUTLET on the 
AV receiver.

■

When playback is started on a component connected 
via 

, the AV receiver automatically selects that 

component as the input source. If your DVD player 
is connected to the AV receiver’s multichannel DVD 
input, you’ll need to press the [MULTI CH] button 
to hear all channels (see page 46), as the Direct 
Change 

 function only selects the FRONT DVD 

IN jacks.

■

You can use the AV receiver’s remote controller to 
control your other 

-capable Onkyo components, 

pointing the remote controller at the AV receiver’s 
remote control sensor instead of the component. You 
must enter the appropriate remote control code first 
(see page 73).

Notes:
• Use only 

 cables for 

 connections. 

 cables 

are supplied with Onkyo players (DVD, CD, etc.).

• Some components have two 

 jacks. You can con-

nect either one to the AV receiver. The other jack is for 
connecting additional 

-capable components.

• Connect only Onkyo components to 

 jacks. Con-

necting other manufacturer’s components may cause a 
malfunction.

• Some components may not support all 

 functions. 

Refer to the manuals supplied with your other Onkyo 
components.

The AV receiver has an AC outlet on its rear panel for 
connecting the power cord of another AV component.
The other component’s power switch can then be left in 
the ON position so that it turns on or off when the AV 
receiver is set to On or Standby.

Caution:
Make sure that the capacity of the component that you 
connect to the AC OUTLET does not exceed the stated 
capacity (e.g., 100W).

Notes:
• Onkyo components with 

 jacks should be con-

nected directly to wall outlets, not the AV receiver’s 
AC OUTLET.

• The socket type and capacity will depend on the coun-

try in which you purchased the AV receiver.

Make sure that each Onkyo component is 
connected to the AV receiver with an analog 
audio cable (connection 

 in the hookup 

examples) (see pages 24 to 35).

Make the 

 connection.

If you’re using an MD, CDR, or HDD com-
ponent, change the input display (see page 
44).