ONKYO HT-RC360 Manual Do Utilizador

En

See “Looking up for Remote Control Code” 
(

With this preference, you can protect your settings by 
locking the setup menus.

■

`

`

When “Locked” is selected, the setup menus will be 
locked and you cannot change any setting.

You can change various audio settings from the Home 
menu (

page 37).

• These settings are not available in either of the following cases:

– a pair of headphones is connected.
– the  “Audio TV Out” setting is set to “On” (

page 53).

– “HDMI Control (RIHD)” is set to “On” (

page 52) and 

you’re listening through your TV speakers.

■

`

–10dB to 0dB to +10dB in 2 dB steps.

You can boost or cut low-frequency sounds output 
from the front speakers.

■

`

–10dB to 0dB to +10dB in 2 dB steps.

You can boost or cut high-frequency sounds output 
from the front speakers.

You can adjust the bass and treble for the front speakers, 
except when the Direct, Pure Audio (Chinese models) 
listening mode is selected.

• To bypass the bass and treble tone circuits, select the Direct, 

Pure Audio (Chinese models) listening mode.

■

`

–15dB to 0dB to +12dB in 1 dB steps.

■

`

–12dB to 0dB to +12dB in 1 dB steps.

You can adjust the volume of each speaker while listening 
to an input source.
These temporary adjustments are cancelled when the AV 
receiver is set to standby. To save the setting you made 
here, go to “Level Calibration” (

setting the AV receiver to standby.

• You cannot use this function while the AV receiver is muted.
• Speakers that are set to “No” or “None” in 

page 43) cannot be adjusted.

■

See “Audyssey” in “Source Setup” (

■

See “Dynamic EQ” in “Source Setup” (

page 46).

■

See “Dynamic Volume” in “Source Setup” (

• These technologies can be used when all the following 

conditions are met:
– Room Correction and Speaker Setup is completed. Note that 

“Audyssey” requires the “Audyssey 2EQ Full Calibration” 
method.

– Any listening mode other than Direct or Pure Audio (Chinese 

models) is selected.

– A pair of headphones is not connected.

• The setting is stored individually for each input selector.

q/w and ENTER to select “Audio”, and then 

q/w/e/r to make the desired selection.