ONKYO HT-RC330 Manual Do Utilizador

En

■

`

`

This function allows the AV receiver to automatically 
correct any delay between the video and the audio, based 
on the data from the connected monitor.

• This function works only if your HDMI-compatible TV supports 

HDMI Lip Sync.

You can change various audio settings from the Home 
menu (

page 26).

• These settings are disabled when the “Audio TV Out” setting is 

set to “On” (

page 35) and an input selector other than 

HDMI is selected.

■

`

–10 dB to 0 dB to +10 dB in 2 dB steps

You can boost or cut low-frequency sounds output 
from the front speakers.

■

`

–10 dB to 0 dB to +10 dB in 2 dB steps

You can boost or cut high-frequency sounds output 
from the front speakers.

You can adjust the bass and treble for Speakers A and B 
front speakers, except when the Direct listening mode is 
selected.

• To bypass the bass and treble tone circuits, select the Direct 

listening mode.

■

`

–15 dB to 0 dB to +12 dB in 1 dB steps

■

`

–12 dB to 0 dB to +12 dB in 1 dB steps

You can adjust the volume of each speaker while listening 
to an input source.
These temporary adjustments are cancelled when the AV 
receiver is set to Standby. To save the setting you made 
here, go to “Level Cal (Level Calibration)” (

page 32) 

before setting the AV receiver to Standby.

• You cannot use this function while the AV receiver is muted.
• Speakers that are set to “No” or “None” in the “Sp Config 

(Speaker Configuration)” (

page 31) cannot be adjusted.

■

For Dolby Digital and Dolby Digital Plus sources, the 
options are:

`

`

Low:

Small reduction in dynamic range.

`

High:

Large reduction in dynamic range.

For Dolby TrueHD sources, the options are:

`

Auto:

The Late Night function is set to “On” or “Off” 
automatically.

`

`

Turn this setting on to reduce the dynamic range of Dolby 
Digital material so that you can still hear quiet parts even 
when listening at low volume levels—ideal for watching 
movies late at night when you don’t want to disturb 
anyone.

• The effect of the Late Night function depends on the material 

that you are playing and the intention of the original sound 
designer, and with some material there will be little or no effect 
when you select the different options.

• The Late Night function can be used only when the input source 

is Dolby Digital, Dolby Digital Plus, or Dolby TrueHD.

• The Late Night function is set to “Off” when the AV receiver is 

set to Standby. For Dolby TrueHD sources, it will be set to 
“Auto”.

After changing the settings of the “HDMI Ctrl 
(RIHD)”, “HDMI Through” or “Audio Return Ch”, 
turn off the power to all connected pieces of equipment 
and then turn them on again. Refer to the instructions 
for all connected pieces of equipment.

q/w and ENTER to select “Audio”, and then 

q/w/e/r to make the desired selection.