ONKYO HT-RC440 Manual Do Utilizador
En-18
Turning On & Basic Operations
Turning On/Off the AV
Receiver
Receiver
Tip
• The HYBRID STANDBY indicator may light depending on the
status of settings (
• For details on power management settings, see “Auto Standby”
).
8RECEIVER
RECEIVER
8ON/STANDBY
Turning On
1
Press
8ON/STANDBY on the front panel.
or
Press
RECEIVER followed by
8RECEIVER on the
remote controller.
The AV receiver comes on and its display lights.
The AV receiver comes on and its display lights.
■
If the “Update New F/W” window appears.
When a new version of the firmware is available, the
notification window “Update New F/W” pops up. This
notification only appears when the AV receiver is
connected to your home network (
notification window “Update New F/W” pops up. This
notification only appears when the AV receiver is
connected to your home network (
perform the firmware update, follow the instructions on
screen.
screen.
Use the
q/w and ENTER buttons on the AV receiver or
remote controller to select one of the options, and then
press ENTER.
press ENTER.
`
Update Now
Starts the firmware update.
Refer to step 4 of “Update procedure”
(
Refer to step 4 of “Update procedure”
(
).
`
Remind me Later
The update notification will pop up again the next
time you turn the AV receiver on.
time you turn the AV receiver on.
`
Never Remind me
Disables the automatic update notification.
Tip
• The update notification window can be enabled or disabled in
“Update Notice” (
).
Turning Off
1
Press
8ON/STANDBY on the front panel.
or
Press
RECEIVER followed by
8RECEIVER on the
remote controller.
The AV receiver will enter standby mode. To prevent
any loud surprises when you turn on the AV receiver,
always turn down the volume before you turn it off.
The AV receiver will enter standby mode. To prevent
any loud surprises when you turn on the AV receiver,
always turn down the volume before you turn it off.