ONKYO HT-RC440 Manual Do Utilizador

Página de 120
Turning On & Basic Operations
En-34
With the sleep timer, you can set the AV receiver to turn 
off automatically after a specified period.
You can adjust the brightness of the AV receiver’s display.
You can display various information about the current 
input source as follows.
The following information can be typically displayed.
*1
When AM or FM radio is used, the band, preset number, and 
frequency are displayed. 
*2
If the input signal is digital, the signal format is displayed. 
Information is displayed for about three seconds, then the 
previously displayed information reappears.
Using the Sleep Timer
1
Press 
RECEIVER once followed by SLEEP 
repeatedly to select the required sleep time.
The sleep time can be set from 90 to 10 minutes in 10 
minute steps.
The SLEEP indicator lights on the AV receiver’s 
display when the sleep timer has been set. The 
specified sleep time appears for about 5 seconds, then 
the previous display reappears.
Tip
• If you need to cancel the sleep timer, press SLEEP 
repeatedly until the SLEEP indicator goes off.
• To check the time remaining until the AV receiver sleeps, 
press SLEEP. Note that if you press again on SLEEP as 
the time being displayed is 10 minutes or less, the sleep 
timer will go off.
Setting the Display Brightness
1
Press 
RECEIVER once followed by DIMMER 
repeatedly to switch between: normal, dim, or 
dimmer brightness.
Tip
• Alternatively, you can use the AV receiver’s DIMMER.
Displaying Source Information
1
Press 
RECEIVER once followed by DISPLAY 
repeatedly to cycle through the available 
information.
Tip
• Alternatively, you can use the AV receiver’s DISPLAY.
Sampling
frequency
Input source
& volume
Signal
format
Listening
mode