Sony CC-222 Manual Do Utilizador
TASCAM CC-222 Owner’s Manual
15
3 – Cassette operations
Note the following when loading tapes:
1
Use your finger or a pencil to turn the cas-
sette's hub and take up any slack tape.
sette's hub and take up any slack tape.
NOTE
Avoid touching the tape. Fingerprints attract dust and
dirt.
dirt.
2
Press the
EJECT
key to open the cassette
compartment door.
3
Load the cassette tape with its open edge fac-
ing down.
ing down.
4
Gently close the compartment door.
NOTE
*Notes:
The cassette holder cannot be opened during recording
or playback.
or playback.
If the power has been switched off during play or
recording, ejecting the cassette may be impossible. In
such a case, switch the power on and press the EJECT
key again.
recording, ejecting the cassette may be impossible. In
such a case, switch the power on and press the EJECT
key again.
Playback operations
1
With the power on, set the
REV MODE
switch
to the required tape mode.
2
Load a pre-recorded cassette with its open
edge facing down and side A facing toward
you.
edge facing down and side A facing toward
you.
3
Set the Dolby NR system on or off.
4
Press either
PLAY
key to start playback.
5
Adjust the volume with the amplifier's vol-
ume control.
ume control.
6
To stop playback, press the
STOP
key.
Continuous tape/CD playback
1
Load the tape (as described above) to be
played back into the unit. Load the disc (use
the
played back into the unit. Load the disc (use
the
OPEN/CLOSE
key and load the disc
recorded side downwards and close the tray).
2
Press the
CD-TAPE CONT PLAY
key.
3
Press either of the
PLAY
keys of the tape
deck, or the
PLAY
key of the CD deck.
Playback will start on the appropriate unit.
When playback reaches the end of the disc,
or the end of the tape (either one side or two
When playback reaches the end of the disc,
or the end of the tape (either one side or two
sides, as determined by the
REV MODE
set-
ting), playback starts on the other unit.
Media (tape or disc) can be changed in the unit that is
not playing.
not playing.
NOTE
The cassette deck and CD deck can be used to play back
through different outputs, or the LINE OUTPUTS 2
jacks can be used for both disc and tape playback. How-
ever, note that if both are playing, the cassette takes
priority (the disc will not be heard through these out-
puts). Disc playback is always through the LINE
OUTPUTS 1
through different outputs, or the LINE OUTPUTS 2
jacks can be used for both disc and tape playback. How-
ever, note that if both are playing, the cassette takes
priority (the disc will not be heard through these out-
puts). Disc playback is always through the LINE
OUTPUTS 1
jacks.
u
Single-sided playback
j
One side, then the other side, then stop
p
One side, then the other side, then the first side again,
etc.
etc.