Pioneer VSX-919AH-S Manual Do Utilizador

En

c,e,f

(PureCinema)

This setting optimizes the picture for film material when the video 
output is set to progressive. Usually set to AUTO; but try 
switching to OFF if the picture appears unnatural.
Additionally, certain PAL movie video (576i, 25 frames/second 
STB video output or DVD disc playback, etc.) that contain film 
progressive material cannot be recognized as such by this 
receiver. In such instances, if you choose PAL, PureCinema mode 
is activated.

c,e

(Progressive Motion)

Adjusts the motion and still picture quality when video output is 

set to progressive.

–4 to +4

Default: 0

c

Adjusts the amount of noise reduction (NR) applied to the Y 
(brightness) component.

0 to +8

Default: 0

c

Adjusts how sharp edges appear.

–4  to  +4

Default: 0

c,g

(Sharpness)

Adjusts the sharpness of the high-frequency (detailed) elements 
in the picture.

–4 to +4

Default: 0

c

(Brightness)

Adjusts the overall brightness.

–6 to +6

Default: 0

c

Adjusts the contrast between light and dark.

–6 to +6

Default: 0

c,h

Adjusts the red/green balance.

–6 to +6

Default: 0

c

(Chroma Level)

Adjusts saturation from dull to bright.

–6 to +6

Default: 0

a.• When set to a resolution with which the TV (monitor) is not compatible, no picture is output. Also, in some cases 

no picture will be output due to copyright protection signals. In this case, change the setting.
• When AUTO is selected, the resolution is selected automatically according to the capacity of the TV (monitor) 
connected by HDMI. When PURE is selected, the signals are output with the same resolution as when input (At this 
time, video signals are only output from the same type of terminals to which they were input).
• When a display is connected by HDMI, if this is set to something other than PURE and 480i/576i analog signals are 
input, 480p/576p signals are output from the component output terminals.
• Conversion to 1080p is only performed for 480i, 576i, 480p and 576p input signals.

b.• If the image doesn’t match your monitor type, adjust the aspect ratio on the source component or on the monitor. 

• NORMAL setting is only displayed when 480i/p or 576i/p video signals are being input.
• This setting is not displayed when 

 is set to PURE.

c.This setting is only displayed when 480i or 576i video signals are being input.
d.If the picture does not display properly when AUTO or PAL is selected, select OFF.
e.This setting is only valid for component outputs.
f. If the picture does not display properly when PAL is selected, select AUTO or OFF.
g.This setting is not valid for HDMI output.
h.This setting is not displayed for component inputs.

VSX-1019_DF.book  67 ページ  ２００９年３月１３日　金曜日　午前９時５８分