Sony STRDG910 Manual Do Utilizador

GB

D:\CANNES\SONY_HA\JOB 2007\STR-
DG910\IM_910_CEL\Data_CEL\GB_data\GB03CON_STR-DG910-CEL.fm

STR-DG910

3-094-430-31 (1)

• Be sure to change the factory setting of the 

VIDEO 2 input button on the remote so that 
you can use the button to control your Blu-
ray disc player. For details, see 
“Programming the remote” (page 78).

• You can also rename the VIDEO 2 input so 

that it can be displayed on the receiver’s 
display. For details, see “Naming inputs” 
(page 76).

• Use a HDMI cable with the HDMI logo 

(made by Sony).

• An audio signal input to the HDMI IN jack 

is output from the SPEAKERS jacks and 
HDMI OUT jack. It is not output from any 
other audio jacks.

• Video signals input to the HDMI IN jack can 

only be output from the HDMI OUT jack. 
The video input signals cannot be output 
from the VIDEO OUT jacks or MONITOR 
OUT jacks.

• When you want to listen to the sound from 

the TV speaker, set “AUDIO” to 
“TV+AMP” in the VIDEO menu (page 54). 
If you cannot play back multi channel 
software, set to “AMP”. However, the sound 
will not output from the TV speaker.

• The multi/stereo area audio signals of a 

Super Audio CD are not output.

• Be sure to turn on the receiver when the 

video and audio of a playback component 
are being output to a TV via the receiver. If 
the power supply of the receiver is not 
turned on, neither video nor audio is 
transmitted.

• Audio signals (sampling frequency, bit 

length, etc.) transmitted from a HDMI jack 
may be suppressed by the connected 
component. Check the setup of the 
connected component if the image is poor or 
the sound does not come out of a component 
connected via the HDMI cable.

• Sound may be interrupted when the 

sampling frequency or the number of 
channels of audio output signals from the 
playback component is switched.

• When the connected component is not 

compatible with copyright protection 
technology (HDCP), the image and/or the 
sound from the HDMI OUT jack may be 
distorted or may not be output. 
In this case, check the specification of the 
connected component.

• Set the resolution of the image of the 

playback component to 720p or 1080i when 
you output 96 kHz multi channel sound over 
a HDMI connection.

• We do not recommend using a HDMI-DVI 

conversion cable. When you connect a 
HDMI-DVI conversion cable to a DVI-D 
component, the sound and/or the image may 
not be output.

• Refer to the operating instructions of each 

connected component for details.