Kenwood PS520 Manual Do Utilizador

LEFT

BRIDGED

SPEAKER
OUTPUT

RIGHT

POWER IN

P.CON

BATT.

GND

FUSE(30Ax2)

ON

OFF

INFRASONIC

FILTER

LPF

OFF

HPF

B.M.S.

+12dB

OFF

REMOTE

OPERATION

MONO(L ch)

STEREO

GND

LINE OUT

EXT.AMP.CONT.

LINE IN

!

@ # $

%

^

(

& *

! Fuse (30 A 

× 2)

@ Battery terminal

# Ground terminal

% Speaker output terminals

When you wish to use the unit as a stereo
amplifier, stereo connections are used.
The speakers to be connected should
have an impedance of 2

Ω or greater.

When multiple speakers are to be
connected, ensure that the combined
impedance is 2

Ω or greater for each

channel.

When you wish to use the unit as a high-
output monaural amplifier, bridged
connections are used. (Make connections
to the LEFT channel 

9 and the RIGHT

channel 

· SPEAKER OUTPUT terminals.)

The speakers to be connected should
have an impedance of 4

Ω or greater.

When multiple speakers are to be
connected, ensure that the combined
impedance is 4

Ω or greater.

The rated input of the speakers should be no
less than the maximum output of the
amplifier. Otherwise malfunction may result.

^ RCA cable ground lead terminal

When using an RCA cable with a ground
lead attached, connect the ground lead to
this terminal.

& LINE IN terminal

* LINE OUT terminal

The signal that’s input from the line input
terminal is output. 

$ Power control terminal

Controls the unit ON/OFF.

Controls the unit power. Be sure to connect it
with all the systems.

( EXT.AMP.CONT. (external

Controls the B.M.S. Only Kenwood center
unit models sold in 1999 or later with a
"EXT.CONT."/"EXT.AMP.CONT." wire
attached can be used. 
Also, a maximum of 3 power amplifiers can
be operated at the same time.

There are cases when operation may not be
possible due to wiring wire type and length.

2CAUTION

■ Terminal names