Yamaha 001PO-03C0 Manual Do Utilizador

If the wire insertion ports are closed, turn the screws on
top of the connector counterclockwise to open the
ports.

Insert the wires into the appropriate ports, following
the indication of the pole on the input terminal, and
turn the screws on top of the connector clockwise to
fasten the wires.

Connect the Euroblock connector to the IPA8200’s
input jack.

From below, insert the spade lug all the way, and tighten the 
screw.

Wrap the conductor around the barrier strip terminal as 
shown below, and tighten the screw. Be sure that the bare 
wire does not touch the chassis.

• Do not connect the pin marked NC located in the center 

of the bottom row of the barrier strip connectors. 

• If using BRIDGE mode, connect the speakers to the “+” 

pin of channels A/C/E/G and the “–” pin of channels B/
D/F/H.

● Cable preparation

• To prepare the cable for attachment to a Euroblock con-

nector, strip the wire as shown in the illustration, and use 
stranded wire to make connections. With a Euroblock 
connection, the stranded wire may be prone to breakage 
because of metal fatigue due to the weight of the cable or 
due to vibration. When rack-mounting your equipment, 
use a lacing bar when possible to bundle and fasten the 
cables.

• If cables will be frequently connected and disconnected, 

as in the case of a portable installation, we recommend 
that you use ferrules with insulation sleeves. Use a ferrule 
whose conductor portion has an external diameter of 1.6 
mm or less, and a length of approximately 7 mm (such as 
the AI0, 5-6WH made by the Phoenix Contact corpora-
tion).

approx. 

7 mm

approx. 

7 mm

1.6 mm

or less

+

–

G

Use a slotted screwdriver 
to fix the wires.

Wires

Euroblock connector

15mm*

* Actual size

Speaker 
cable

Wire should 
not touch 
the chassis.

NOTE