Yamaha YSP-4300 Manual Do Utilizador
Initial settings
26
En
S/T
SETUP
RETURN
ENTER
X
AUTO SETUP via setup menu
1
Place the IntelliBeam microphone at your
normal listening position, and press the
SETUP key.
normal listening position, and press the
SETUP key.
☞p. 23) for
instructions on positioning the IntelliBeam microphone.
2
Press the
S/T key to select “BEAM” and
then press the
X key.
1)
3
Press the
S/T key to select “IntelliBeam”
and then press the
X key.
1)
4
Press the
S/T key to select one of the
items below and then press the
X key.
1)
Select Item:
“BEAM+SOUND OPTIMIZE”
(Beam optimization and sound optimization)
Select this optimization feature if you make settings for the
first time. This menu takes about 3 minutes.
“BEAM OPTIMIZE ONLY”
(Beam optimization only)
Use to optimize the beam angle so that the parameter best
matches your listening environment. This menu takes about
1 minute.
“SOUND OPTIMIZE ONLY”
(Sound optimization only)
Use to optimize the beam delay, volume, and quality so that
the parameters best match your listening environment. This
menu takes about 2 minutes.
You must optimize the beam angle with “BEAM
OPTIMIZE ONLY” before starting “SOUND OPTIMIZE
ONLY”. Select this optimization feature in the following
cases:
• If you have opened or closed the curtains in your
“BEAM+SOUND OPTIMIZE”
(Beam optimization and sound optimization)
Select this optimization feature if you make settings for the
first time. This menu takes about 3 minutes.
“BEAM OPTIMIZE ONLY”
(Beam optimization only)
Use to optimize the beam angle so that the parameter best
matches your listening environment. This menu takes about
1 minute.
“SOUND OPTIMIZE ONLY”
(Sound optimization only)
Use to optimize the beam delay, volume, and quality so that
the parameters best match your listening environment. This
menu takes about 2 minutes.
You must optimize the beam angle with “BEAM
OPTIMIZE ONLY” before starting “SOUND OPTIMIZE
ONLY”. Select this optimization feature in the following
cases:
• If you have opened or closed the curtains in your
listening room before using this unit
• If you have manually set the beam angle.
5
Connect the IntelliBeam microphone to
this unit after “AUTO SETUP
(PREPARATION & CHECK)” screen is
displayed.
this unit after “AUTO SETUP
(PREPARATION & CHECK)” screen is
displayed.
For the details on connecting IntelliBeam microphone,
refer to “Using AUTO SETUP (IntelliBeam)” (
refer to “Using AUTO SETUP (IntelliBeam)” (
6
Follow steps 4, 5, and 6 under “Using
AUTO SETUP (IntelliBeam)” to configure
settings, and then remove the microphone.
AUTO SETUP (IntelliBeam)” to configure
settings, and then remove the microphone.
The ENTER key performs the same function as the X key.
1)
y