Turbosound TCS-C50T Manual Do Utilizador

 

 

 
1.

 

Select the ceiling tile(s) to be used for mounting the loudspeaker(s) and remove it 
from the ceiling. Mark the cutout either by tracing from the cardboard template 
supplied with the loudspeaker, or by placing the tile bridge on the rear side of the 
tile, making sure that it is centred in both directions. Cut the hole with a knife or with 
a circular cutter set to 240mm (9 7/16”). 

 
 

Ø240

 

 
 

2.

 

Remove the loudspeaker grille by pushing on the speaker attachment tabs.  

 

 

 
Loosen the four attachment screws and fold the tabs sideways until they touch the 
steel back can, allowing the speaker to pass freely through the cutout. Assemble the 
speaker, tile bridge and tile together and tighten the attachment screws to tighten 
the mounting tabs. Note that the first 1/4 turn rotates the tab outwards and away 
from the can, and subsequent turns tighten the tab down onto the ceiling tile. DO 
NOT OVERTIGHTEN. 

3.

 

The tile grid is designed to fit either 24” or 600mm wide tiles. The tile grid does not 
physically attach to the T-grid struts; instead the inverted V-shapes at the ends sit 
over the top of the T-grid struts. During normal circumstances the speaker is 
supported by the edge of the tile. In the unlikely event that the tile should come out 
or fall apart, the ends of the tile grid are designed to catch onto the T-grid, thereby 
preventing the loudspeaker from falling.