RBH Sound MCS-88 Manual Do Utilizador
RBH
INWALL
S
UBWOOFER
INSTALLATION
AND
INSTRUCTION
MANUAL
Congratulations on your purchase of the RBH MCS-88 subwoofer! Your subwoofer is the
result of many years of research and development dedicated to producing high quality
products for home audio and audio/video systems. This manual is designed to give you,
the installer or owner, basic information as to the subwoofers installation and operation.
result of many years of research and development dedicated to producing high quality
products for home audio and audio/video systems. This manual is designed to give you,
the installer or owner, basic information as to the subwoofers installation and operation.
T
ECHNOLOGY
At the heart of the MCS-88 is a proprietary aluminum woofer. The special aluminum
cone combines stiffness, low mass and self damping properties in a manner that al-
lows virtually uncolored presentation of program material. A powerful magnet and
extended voice coil give the woofers high excursion capability, which ensures accurate
dynamic reproduction.
cone combines stiffness, low mass and self damping properties in a manner that al-
lows virtually uncolored presentation of program material. A powerful magnet and
extended voice coil give the woofers high excursion capability, which ensures accurate
dynamic reproduction.
P
AINTING
RBH in-wall subwoofer frames and grilles can be painted any color to match any decor.
A plastic paint shield is supplied and placed inside the grille to protect the speaker from
becoming damaged during painting.
A plastic paint shield is supplied and placed inside the grille to protect the speaker from
becoming damaged during painting.
PLEASE NOTE: This plastic paint shield must
be removed before operation of the speaker begins.
The MCS-88 utilizes a defeatable crossover network. This crossover is fixed at 100Hz
low-pass when the switch is set to “On”; the subwoofer will then only play frequencies
100Hz and below. All frequencies above 100 Hz will be reduced by 12dB per octave.
When set to “Off”, the subwoofer will play the full range of frequencies. This switch
should be in the “On” position when the signal sent to the subwoofer is ‘full-range’ or
not previously filtered through a crossover. The switch should be set to “Off” when the
signal sent to the subwoofer is coming from a source using a crossover, such as the
subwoofer pre-out from some receivers or pre-amplifiers. Please refer to your receiver
or pre-amplifier owners manual for proper bass management settings information. This
will ensure that the subwoofer is not receiving a signal filtered through two crossovers.
We suggest consulting with your installer, or experimenting with the crossover on and
off to determine which is best for your system.
low-pass when the switch is set to “On”; the subwoofer will then only play frequencies
100Hz and below. All frequencies above 100 Hz will be reduced by 12dB per octave.
When set to “Off”, the subwoofer will play the full range of frequencies. This switch
should be in the “On” position when the signal sent to the subwoofer is ‘full-range’ or
not previously filtered through a crossover. The switch should be set to “Off” when the
signal sent to the subwoofer is coming from a source using a crossover, such as the
subwoofer pre-out from some receivers or pre-amplifiers. Please refer to your receiver
or pre-amplifier owners manual for proper bass management settings information. This
will ensure that the subwoofer is not receiving a signal filtered through two crossovers.
We suggest consulting with your installer, or experimenting with the crossover on and
off to determine which is best for your system.
C
ROSSOVER