Yamaha HTR-5990 Manual Do Utilizador

■ Connecting the AC power cable
Plug the supplied AC power cable into the AC inlet after 
all other connections are complete, then plug the AC 
power cable to an AC wall outlet.

Use the supplied AC cable. Do not use other AC power cables as 
doing so may result in fire hazard or electrical shock.

■ AC OUTLETS (SWITCHED)
Use these 2 outlets to supply power to any connected 
components. Connect the AC power cables of your other 
components to these 2 outlets. Power to these 2 outlets is 
supplied when the main room, Zone 2 or Zone 3 is turned 
on. However, power to these 2 outlets is cut off when the 
main room, Zone 2 and Zone 3 are turned off or when 
MASTER ON/OFF on the front panel is pressed and 
released outward to the OFF position. The maximum 
power or the total power consumption of the components 
that can be connected to these 2 outlets is 100 W.

When all connections are complete, turn on the power of 
this unit.

Press MASTER ON/OFF on the front panel 
inward to the ON position to turn on the 
power of this unit.
• Only this unit is turned on.
• Zone 2 and Zone 3 are set to the standby mode.

Memory back-up
The memory back-up circuit prevents the stored data 
from being lost. However, the stored data will be lost 
in case the power cord is disconnected from the AC 
wall outlet for more than one week.

l  PRESET/TUNING/CH  h