Yamaha RX-V4600 Manual Do Utilizador

You can use the REC OUT/ZONE 2 control to record one 
source while watching and/or listening to another source.

Recording adjustments and other operations are 
performed from the recording components. Refer to the 
operation instructions for those components.

Select the source component you want to 
record from by using REC OUT/ZONE 2.
• To record the current input source that you are 

watching or listening to, set REC OUT/ZONE 2 to 
SOURCE/REMOTE.

• To record a source other than the one that you are 

watching or listening to, set REC OUT/ZONE 2 to 
the source you want to record.

After this setting, you can change the source you 
are listening to and/or watching without effecting 
the recording by rotating the INPUT selector (or 
pressing one of the input selector buttons on the 
remote control).

y

• To record audio and video from different sources, set REC 

OUT/ZONE 2 to SOURCE/REMOTE, select a video source 
first then select an audio source (see page 39).

• Do a test recording before you start an actual recording.

• The source you record and the source sent to Zone 2 are always 

the same.

• When this unit is set in the standby mode, you cannot record 

between other components connected to this unit.

• The setting of TONE CONTROL, (see page 60) VOLUME, 

Speaker Level (page 65) and programs does not affect recorded 
material.

• A source connected to the MULTI CH INPUT jacks of this unit 

cannot be recorded.

• S-video and composite video signals pass independently 

through this unit’s video circuits. Therefore, when recording or 
dubbing video signals, if your video source component is 
connected to provide only an S-video (or only a composite 
video) signal, you can record only an S-video (or only a 
composite video) signal to your VCR.

• Digital signals input at the DIGITAL INPUT jacks are not 

output at the analog AUDIO OUT (L/R) jacks for recording. 
Likewise, analog signals input at the AUDIO IN (L/R) jacks are 
not output at the DIGITAL OUTPUT jack. Therefore, if your 
source component is connected to provide only digital (or 
analog) signals, you can only record digital (or analog) signals.

• A given input source is not output on the same REC OUT 

channel. (For example, the signal input from VCR 1 IN is not 
output on VCR 1 OUT.)

• Check the copyright laws in your country to record from 

records, CDs, radio, etc. Recording of copyrighted material may 
infringe copyright laws.

• Audio signals input from the selected i.LINK or HDMI 

components are output to REC OUT when REC OUT/ZONE 2 
on the front panel is set to SOURCE/REMOTE or to the source 
you want to record. However, multi-channel DVD audio 
signals, DSD signals of Super Audio CD and 2-channel PCM 
signals over 48 kHz of sampling frequency cannot be output to 
REC OUT.

■ Special considerations when recording 

The DTS signal is a digital bitstream. Attempting to 
digitally record the DTS bitstream will result in noise 
being recorded. Therefore, if you want to use this unit to 
record sources that have DTS signals recorded on them, 
the following considerations and adjustments need to be 
made.
For DVDs and CDs encoded with DTS, when your player 
is compatible with the DTS format, follow its operation 
instruction to make a setting so that the analog signal will 
be output from the player.

If you play back a video source that uses scrambled or 
encoded signals to prevent it from being dubbed, the 
picture itself may be disturbed due to those signals.