Yamaha RX-V4600 Manual Do Utilizador

You can change the name that appears in the display 
window on the remote control if you want to use a 
different name than the factory preset. This is useful when 
you have set the input selector to control a different 
component.

source component you want to rename.
The selected component name appears in the display 
window.

If you do not complete each of the following steps within 30 
seconds, the renaming mode will be automatically canceled. 
In this case, press RE-NAME again.

Press k / n to select and enter a character.
Pressing n changes the character as follows: 
A to Z, 1 to 9, 0, + (plus), – (hyphen), ; (semicolon), 
/ (slash), and space. 
(Pressing k changes the characters in reverse order.)

Press l / h to move the cursor to the next 
position.

Press ENTER to set the new name.
“OK” appears in the display window if renaming was 
successful.
“NG” appears in the display window if renaming was 
unsuccessful. In this case, start over from step 4.

y

If you continuously want to rename another component, 
press the input selector button or SELECT k / n to select 
the component, then repeat steps 4 through 6.

“ERROR” appears in the display window if you press a button 
not indicated in the respective step, or when you press more than 
one button simultaneously.

RE-NAME

RE-NAME