Yamaha RX-V4600 Manual Do Utilizador

The supplied remote control can be used to control 
Zone 2/Zone 3. You can even select the input source and 
control components located in the main room directly 
from the second/third room regardless of the listening 
condition in the main room.

■ To enable Zone mode on the remote 

You will be able to switch the remote control mode from 
one room to another, and use the input selector, 
STANDBY, SYSTEM POWER, MUTE and 
VOLUME +/– to control the selected room.

Repeat steps 1 through 3 of the procedure in 
“Setting remote control codes” on page 71.

Press l / h to select “L;AMP”.

Press ENTER.
“2000” appears in the display window.

Enter the code number “2001” or “2003”.
For details, see page 72.

Press ENTER to set the number.
“OK” appears in the display window if setting was 
successful.

Press LEARN to complete the Zone setup.
The remote control will be able to operate this unit 
from Zone 2 or Zone 3.

■ To control Zone 2/Zone 3

Press SELECT k repeatedly to display 
“ZONE 2” or “ZONE 3” in the display window.

Press an input selector button to select the 
input source you want to listen to in the 
second/third room.
The display window shows “2: name of selected 
input” or “3: name of selected input” if the remote 
control is in the Zone 2/Zone 3 mode.

Signals input at V-AUX and PHONO jacks cannot be sent to 
Zone 2/Zone 3.

* VOLUME +/– can be used only when Zone2 Volume or 

Zone3 Volume is set to “Variable” in the GUI menu 
(see page 67).

LEARN

*