Yamaha RX-V659 Manual Do Utilizador

Once you have connected the supplied optimizer 
microphone to the OPTIMIZER MIC jack on the front 
panel and have placed it in a suitable location in your 
listening room, run “AUTO SETUP” in the OSD or in the 
front panel display.

To achieve the best results, make sure the room is as quiet as 
possible while the “AUTO SETUP” procedure is in progress. If 
there is too much ambient noise, the results may not be 
satisfactory.

y

• You can run “AUTO SETUP” using the system menu that 

appears in the OSD or in the front panel display. This manual 
uses the OSD illustrations to explain the “AUTO SETUP” 
procedure.

• If an error occurs during the “AUTO SETUP” procedure and an 

error or warning message appears in the OSD or in the front 
panel display, see the “AUTO SETUP” section in 
“TROUBLESHOOTING” on pages 116 and 117 for a complete 
list of error and warning messages and proper remedies.

• The initial setting for each parameter is indicated in bold.
• If the volume level and the crossover frequency of your 

subwoofer can be adjusted, set the volume level to about half 
way (or slightly less) and set the crossover frequency to the 
maximum.

Set the component selector switch to AMP 
and then press SET MENU to enter “SET 
MENU”.
The top “SET MENU” display appears in the OSD.

Press u / d to select “AUTO SETUP”.

Press ENTER to enter “AUTO SETUP”.
The “AUTO:MENU” display appears in the OSD.

SET MENU

.;AUTOSETUP

;MANUALSETUP

.;SIGNAL INFO

[ ]/[]:Up/Down
[ENTER]:Enter

p

p

SET MENU

.;AUTOSETUP

;MANUALSETUP

.;SIGNAL INFO

[ ]/[]:Up/Down
[ENTER]:Enter

p

p

1 AUTO:MENU

.SETUP;;;;;;;AUTO

START

Automatic
processing
of all items

[]/[]:Up/Down
[<]/[>]:Select

p

p