Sony TA-E9000ES Manual Do Utilizador
44
GB
Additional Information
No sound or only a very low-level sound is heard
from the rear speakers.
from the rear speakers.
/ Make sure the sound field function is on (press
AUTO FORMAT).
/ Adjust the speaker volume (see page 22).
/ Make sure the rear speaker size parameter is set to
/ Make sure the rear speaker size parameter is set to
either SMALL or LARGE (see page 18).
Recording cannot be done.
/ Check that the components are connected correctly.
/ Select the source component by rotating the
/ Select the source component by rotating the
INPUT SELECTOR control.
/ When recording from a digital component, be sure
to press DIGITAL/ANALOG to select “ANALOG”
(see page 13) before recording with a component
connected to the analog MD/DAT, TAPE, VIDEO
1, VIDEO 2, or VIDEO 3 terminals.
(see page 13) before recording with a component
connected to the analog MD/DAT, TAPE, VIDEO
1, VIDEO 2, or VIDEO 3 terminals.
/ When recording from a digital component, be sure
to press DIGITAL/ANALOG to select “DIGITAL”
(see page 13) before recording with the component
connected to the MD/DAT OPTICAL OUT
terminals.
(see page 13) before recording with the component
connected to the MD/DAT OPTICAL OUT
terminals.
The surround effect cannot be obtained.
/ Make sure the sound field function is on (press
AUTO FORMAT).
No picture or an unclear picture appears on the
TV screen or monitor.
TV screen or monitor.
/ Select the appropriate function on the control
amplifier.
/ Set your TV to the appropriate input mode.
/ Move your TV away from the audio components.
/ Move your TV away from the audio components.
The audio output does not correspond to the
video image on the TV screen or monitor.
video image on the TV screen or monitor.
/ Check the source of the audio signal by pressing
AUDIO SPLIT to display "V:(video component)
A:(audio component)". Hold down AUDIO SPLIT
for more than 2 seconds to cancel the function and
restore both audio and video to the selected video
component.
A:(audio component)". Hold down AUDIO SPLIT
for more than 2 seconds to cancel the function and
restore both audio and video to the selected video
component.
The remote does not function.
/ Point the remote at the remote sensor g on the
control amplifier.
/ Remove any obstacles in the path between the
remote and the control amplifier.
/ Replace all batteries in the remote with new ones,
if they are weak.
/ Make sure you select the correct function on the
remote.
/ If the remote is set to operate the TV only, use the
remote to select a source or component other than
TV before operating the control amplifier or other
component.
TV before operating the control amplifier or other
component.
Reference sections for clearing the control
amplifier’s memory
amplifier’s memory
To clear
See
All memorized settings
Page 17
Customized equalizers
Page 40
Troubleshooting