Sony MHC-EC619iP Manual
26
GB
MHC-EC619iP.4-467-785-22(1)
Transferring results in an error.
Check the information on websites
for compatible USB devices using
the URLs listed under “USB devices”
The USB device is not formatted
correctly. Refer to the operating
instructions of the USB device on
how to format.
Turn off the system and remove the
USB device. If the USB device has a
power switch, turn the USB device
off and then on again after removing
it from the system. Then perform
transferring again.
The USB device was disconnected
or the power was turned off during
transferring. Delete the partially
transferred file, and perform
transferring again. If this does not
fix the problem, the USB device may
be broken. Refer to the operating
instructions of the USB device on
how to deal with this problem.
Audio files or folders on the USB device
cannot be erased.
cannot be erased.
Check if the USB device is write-
protected.
The USB device was disconnected
or the power was turned off during
the erase operation. Delete the
partially-erased file. If this does
not fix the problem, the USB device
may be broken. Refer to operating
instructions of the USB device on
how to deal with this problem.
Play does not start.
Turn off the system and reconnect
the USB device, then turn on the
system.
Check the information on websites
for compatible USB devices using
the URLs listed under “USB devices“
Press to start playback.
Play does not start from the first track.
Set the play mode to normal play
mode.
Files cannot be played back.
The audio files may have
inappropriate file extensions. The file
extensions supported by this system
are as follows:
MP3: file extension “.mp3”
WMA: file extension “.wma”
USB storage devices formatted with
file systems other than FAT16 or
FAT32 are unsupported.*
If you use a partitioned USB storage
device, only files on the first partition
can be played.
Files that are encrypted or protected
by passwords, etc. cannot be played
back.
* This system supports FAT16 and FAT32,
but some USB storage devices may not
support all of these FAT. For details, see
the operation manual of each USB storage
device or contact the manufacturer.
Tuner
Severe hum or noise, or stations
cannot be received.
cannot be received.
Connect the antenna properly.
Try another place and orientation for
Try another place and orientation for
better antenna reception.
Keep the antenna away from the
speaker cords and the power cord to
avoid picking up noise.
Turn off nearby electrical equipment.
To reset the system to factory
settings
settings
If the system still does not operate
properly, reset the system to factory
settings.
1
Disconnect and reconnect the
power cord, and then turn on the
system.
power cord, and then turn on the
system.
2
Hold down
and EQ on the unit
until “RESET OK” appears.
All user-configured settings, such
All user-configured settings, such
as preset radio stations, timer, and
the clock, are deleted.