Sony STR-DG520 Manual Do Utilizador

C:\Documents and 
Settings\pc13\Desktop\JC071253_3284083111DG520_US\3284083111\US07OTH_STR-DG520-
U.fm

STR-DG520

3-284-083-11(1)

• Check that the components are connected 

correctly.

• Select the source component using the 

input buttons.

• Use a 75-ohm coaxial cable (not supplied) 

to connect the receiver to an outdoor FM 
antenna (aerial) as shown below. If you 
connect the receiver to an outdoor antenna 
(aerial), ground it against lightning. To 
prevent a gas explosion, do not connect the 
ground wire to a gas pipe.

• Check that the antennas (aerials) are 

connected securely. Adjust the antennas 
(aerials) and connect an external antenna 
(aerial), if necessary.

• The signal strength of the stations is too 

weak (when tuning in with automatic 
tuning). Use direct tuning.

• Make sure you set the tuning interval 

correctly (when tuning in AM stations 
with direct tuning).

• No stations have been preset or the preset 

stations have been cleared (when tuning by 
scanning preset stations). Preset the 
stations (page 47).

• Press DISPLAY repeatedly on the receiver 

so that the frequency appears on the 
display.

• Point the remote at the remote sensor on 

the receiver.

• Remove any obstacles in the path between 

the remote and the receiver.

• Replace all the batteries in the remote with 

new ones, if they are weak.

• Make sure you select the correct input on 

the remote.

AM

Receiver

To ground

Ground wire 
(not supplied) 

Outdoor FM antenna (aerial)