Sony STR-DE985 Manual
60
US
STR-DE985/DE885 4-238-488-12(1) US
To connect an LD player via an RF demodulator.
Connect the LD player to the RF demodulator,
then connect the RF demodulator’s optical or
coaxial digital output to the receiver’s jack. When
making this connection, be sure to set INPUT
MODE manually (page 26). The receiver may not
operate correctly if INPUT MODE is set to
“AUTO 2CH”. For details on DOLBY DIGITAL
RF hookups, see the operating instructions
supplied with your RF demodulator.
then connect the RF demodulator’s optical or
coaxial digital output to the receiver’s jack. When
making this connection, be sure to set INPUT
MODE manually (page 26). The receiver may not
operate correctly if INPUT MODE is set to
“AUTO 2CH”. For details on DOLBY DIGITAL
RF hookups, see the operating instructions
supplied with your RF demodulator.
The FM reception is poor.
Use a 75-ohm coaxial cable (not supplied) to
connect the receiver to an outdoor FM antenna as
shown below. If you connect the receiver to an
outdoor antenna, ground it against lightning. To
prevent a gas explosion, do not connect the ground
wire to a gas pipe.
connect the receiver to an outdoor FM antenna as
shown below. If you connect the receiver to an
outdoor antenna, ground it against lightning. To
prevent a gas explosion, do not connect the ground
wire to a gas pipe.
Radio stations cannot be tuned in.
• Check that the antennas are connected securely.
Adjust the antennas and connect an external
antenna if necessary.
antenna if necessary.
• The signal strength of the stations is too weak
(when tuning in with automatic tuning). Use
direct tuning.
direct tuning.
• Make sure you set the tuning interval correctly
(when tuning in AM stations with direct tuning).
• No stations have been preset or the preset
stations have been cleared (when tuning by
scanning preset stations). Preset the stations
(page 41).
scanning preset stations). Preset the stations
(page 41).
• Press DISPLAY so that the frequency appears in
the display.
Outdoor FM antenna
Receiver
Ground wire
(not supplied)
(not supplied)
To ground
FM
75
Ω
COAXIAL
y
AM
ANTENNA
Troubleshooting (continued)
There is no picture or an unclear picture appears
on the TV screen or monitor.
on the TV screen or monitor.
• Select the appropriate function on the receiver.
• Set your TV to the appropriate input mode.
• Move your TV away from the audio components.
The remote does not function.
• The MPX/DUAL and 12 buttons on the remote
are not available (RM-PG411 only).
• The AUX, SOURCE, MPX/DAUL, 12 and ON
SCREEN buttons on the remote are not available
(RM-PP411 only).
(RM-PP411 only).
• Point the remote at the remote sensor
g on the
receiver.
• Check that the mode of the remote corresponds
to that of the receiver (page 44 and 52).
• Remove any obstacles in the path between the
remote and the receiver.
• Replace both batteries in the remote with new
ones, if they are weak.
• Make sure you select the correct function on the
remote.
• Press MAIN MENU on the remote before you
use the
V/v/B/b buttons for receiver operation
(page 51).
Clearing the receiver’s memory
To clear
See
All memorized settings
page 19
Customized sound fields
page 39
01GB10ADDUS.p65
25/3/02, 02:48 PM
60