Sony ACY-RKSL Manual Do Utilizador

Mounting the S-AIT Library in the Rack

14

Depending on your rack, the clearance between the rack 
and the rail may be so small that the rail comes in contact 
with the rack, making the rail difficult to slide in and out.

To remedy this problem, we recommend that you install 
the supplied rail guides on the front brackets when 
preparing the rack for the S-AIT library.

Install the rail guides on the front brackets.
Install the rail guide so that it fits snugly against the 
bracket, then secure it with a A screw (B4 

× 5).

Each rail guide can be installed on the left or right 
bracket. However, because the rail guides have a 
slight bend at one end, make sure that you do not 
install them inside out.

Install the opposite rail guide as explained in step 1.

Mount the rail assemblies on the brackets.
The rails slide in and out smoothly.

Insert the library into the rack, and then secure the 
brackets.

With a single drive installed, the S-AIT library weighs 
approximately 27 kg/59.5 lbs. (With two drives 
installed, the S-AIT library weighs approximately 31 
kg/68.3 lbs.)
At least two people are needed in order to handle the 
library. Handling the S-AIT library on your own could 
result in back injury or other accidents resulting in injury 
or damage to the S-AIT library.

Pull the straight rails out from the rail assemblies.

Have two or more people lift the library, fit the inner 
rails into the rail assemblies, and then slide the 
inner rails to the locking arm position.
The library will not slide past the locking arm 
position.

Slide rail

Slide rail

Bracket

Rack

Rail assembly

Rack

Obstruction

Bracket

Rail guide snugly fitted 
against the bracket

A screw (B4 

× 5)

Small hole position 
(relative to the screw hole)
• Right rail guide: above
• Left rail guide: under

Inner rail

Rail assembly

Locking arm