TEAC MCDV600 Manual Do Utilizador

< To listen to an external source connected to the AUX IN jack, 

select AUX1 or AUX2. 

< You can also select AUX1 or AUX2 by pressing the AUX button 

on the remote control unit once or twice.

The volume is adjustable from MIN to MAX. You can hold down 
the VOLUME – or + buttons on the remote control unit to reduce 
or bring up the volume continuously. 

< Press the STANDBY/ON button to put the unit in the standby 

mode when it is not being used.

When you press the STANDBY/ON button to put the unit in the 
standby mode, “ECO POWER” is shown on the display first, then 
the clock is shown in a few seconds before the unit turns off the 
display to save the power consumption.
<  In ECO Power Standby mode, the illumination of the STANDBY/

ON button lights orange.

To show the clock on the display during ECO Power Standby 
mode, press the CLOCK button. The illumination of STANDBY/ON 
button turns off.
< If no operation is done for a few minutes, the unit switches to 

ECO Power Standby mode again.

This chapter describes the basic operation which is available in every 
mode.
When you use the unit for the first time, set the clock and the setting 
of the unit. (see previous page for “Setting the Clock” and page 33 for 
“Settings”).

<  The unit turns on with the source that was last selected.

< You can also use the FUNCTION button (or the FM, DVD, USB or 

AUX button on the remote control unit) to turn the unit on.

Each time the FUNCTION button is pressed, the source changes 
as follows:

The selected source is shown on the front panel display.