TEAC MCDV600 Manual Do Utilizador

You can select the audio signal output suitable for the connected 
device when playing the digital source.

Select this when you do not use the DIGITAL OUT or HDMI out 
terminal.
No signal is output from these terminals.

Select this when the unit is connected to an audio component 
equipped with a built-in digital audio decoder via the DIGITAL OUT 
or the HDMI out terminal.

Select this when the unit is connected to an audio component 
such as amplifier/receiver, CD recorder or MD deck via the DIGITAL 
OUT or the HDMI out terminal.

You can select the channel output for the DVD discs recorded in 
Dolby digital.

Left channel is output from the left speaker, and right channel is 
output from the right speaker.

Left channel is output from the front left and right speakers.

Right channel is output from the front left and right speakers.

This setting provides following sound effects by using just two 
speakers:

This setting can cause delays in the sound signal in 10 ms increments 
ranging from 0 ms to 200 ms (only for digital signals recorded on a 
disc or stored in an USB device; unavailable for analog signals coming 
from AUX 1 or 2).

Depending on the TV, it may take approximately 100 ms (0.1 sec.) for 
an image to appear after video signals are input, causing the image 
to appear after the sound coming from the MC-DV600 is heard.

If this happens or audio and video synchronization creates a less 
than optimal viewing experience, adjust the delay with the left 
(decrease) or right (increase) Cursor (g/t) buttons.