TEAC MCDV600 Manual Do Utilizador

Confirm the supplied standard accessories.

<  Keep this manual in a safe place for future reference.

When the unit is moved from a cold to a warm place, or used after a 
sudden temperature change, there is a danger of condensation; vapor 
in the air could condense on the internal mechanism, making correct 
operation impossible. To prevent this, or if this occurs, leave the unit 
turned on for one or two hours. Then the unit will stabilize at the 
temperature of its surroundings.

<  Choose the installation location of your unit carefully. Avoid placing 

it in direct sunlight or close to a source of heat. Also avoid locations 
subject to vibrations and excessive dust, heat, cold or moisture.

< As the unit may become warm during operation, always leave 

sufficient space around the unit for ventilation.

  Make sure there is at least 8” (20 cm) of space above and at least 2” 

(5 cm) of space on each side of the unit. Do not place anything on 
top of the unit.

< Do not place the unit on an amplifier or receiver or any other 

device that generates heat.

<  When the unit is turned on, switching on the TV may cause lines 

to appear on the TV screen, depending on the condition of the 
electric waves of the TV broadcast. This is not malfunction in the 
unit or the TV. If you see such lines, keep this unit well away from 
the TV set.

<  Do not move the unit during disc playback.

During playback, the disc rotates at high speed. Do not lift or 
move the unit during playback. Doing so may damage the disc 
or the unit.

< The voltage supplied to the unit should match the voltage as 

printed on the rear panel. If you are in any doubt regarding this 
matter, consult an electrician.

< Do not open the cabinet as this might result in damage to the 

circuitry or electrical shock. If a foreign object should get into the 
unit, contact your dealer or service company.

<  When removing the power plug from the wall outlet, always pull 

directly on the plug, never yank on the cord.

<  To keep the laser pickup clean, do not touch it and always close 

the disc tray.

< Always remove the disc before relocating or moving this unit. 

Moving the unit with a disc inside it could cause malfunction.

If the surface of the unit gets dirty, wipe it with a soft cloth or 
use diluted mild liquid soap. Allow the surface of the unit to dry 
completely before using.

 

For safety, disconnect the power cord from the socket before   
cleaning.

<  Never spray liquid directly on this unit.

<  Do not use thinner or alcohol as they could damage the surface of 

the unit.