Renesas SH7709S Manual Do Utilizador
Rev. 5.00, 09/03, page 96 of 760
•
TLB invalid exception
Conditions: Comparison of TLB addresses shows address match but the TLB entry valid
bit (V) is 0.
bit (V) is 0.
Operations: The virtual address (32 bits) that caused the exception is set in TEA and the
corresponding virtual page number (22 bits) is set in PTEH (31–10). The ASID of PTEH
indicates the ASID at the time the exception occurred. The way that generated the
exception is set in the RC bits in MMUCR.
corresponding virtual page number (22 bits) is set in PTEH (31–10). The ASID of PTEH
indicates the ASID at the time the exception occurred. The way that generated the
exception is set in the RC bits in MMUCR.
PC and SR of the instruction that generated the exception are saved to SPC and SSR,
respectively. If the exception occurred during a read, H'040 is set in EXPEVT; if the exception
occurred during a write, H'060 is set in EXPEVT. The BL, MD, and RB bits in SR are set to 1
and a branch occurs to PC
respectively. If the exception occurred during a read, H'040 is set in EXPEVT; if the exception
occurred during a write, H'060 is set in EXPEVT. The BL, MD, and RB bits in SR are set to 1
and a branch occurs to PC
=
VBR + H'0100.
•
Initial page write exception
Conditions: A hit occurred to the TLB for a store access, but the TLB entry data bit (D) is
0.
This occurs for initial writes to the page registered by the load.
0.
This occurs for initial writes to the page registered by the load.
Operations: The virtual address (32 bits) that caused the exception is set in TEA and the
corresponding virtual page number (22 bits) is set in PTEH (31–10). The ASID of PTEH
indicates the ASID at the time the exception occurred. The way that generated the
exception is set in the RC bit in MMUCR.
corresponding virtual page number (22 bits) is set in PTEH (31–10). The ASID of PTEH
indicates the ASID at the time the exception occurred. The way that generated the
exception is set in the RC bit in MMUCR.
PC and SR of the instruction that generated the exception are saved to SPC and SSR,
respectively. H'080 is set in EXPEVT. The BL, MD, and RB bits in SR are set to 1 and a
branch occurs to PC
respectively. H'080 is set in EXPEVT. The BL, MD, and RB bits in SR are set to 1 and a
branch occurs to PC
=
VBR + H'0100.
•
TLB protection exception
Conditions: When a hit access violates the TLB protection information (PR bits) shown
below:
below:
PR
Privileged mode
User mode
00
Only read enabled
No access
01
Read/write enabled
No access
10
Only read enabled
Only read enabled
11
Read/write enabled
Read/write enabled
Operations: The virtual address (32 bits) that caused the exception is set in TEA and the
corresponding virtual page number (22 bits) is set in PTEH (31–10). The ASID of PTEH
indicates the ASID at the time the exception occurred. The way that generated the
exception is set in the RC bits in MMUCR.
corresponding virtual page number (22 bits) is set in PTEH (31–10). The ASID of PTEH
indicates the ASID at the time the exception occurred. The way that generated the
exception is set in the RC bits in MMUCR.
PC and SR of the instruction that generated the exception are saved to SPC and SSR,
respectively. If the exception occurred during a read, H'0A0 is set in EXPEVT; if the exception
occurred during a write, H'0C0 is set in EXPEVT. The BL, MD, and RB bits in SR are set to 1
and a branch occurs to PC
respectively. If the exception occurred during a read, H'0A0 is set in EXPEVT; if the exception
occurred during a write, H'0C0 is set in EXPEVT. The BL, MD, and RB bits in SR are set to 1
and a branch occurs to PC
=
VBR + H'0100.