Renesas SH7709S Manual Do Utilizador

Rev. 5.00, 09/03, page 464 of 760

In receiving, the SCI operates as follows:

1. The SCI monitors the communication line. When it detects a start bit (0), the SCI synchronizes

internally and starts receiving.

2. Receive data is shifted into SCRSR in order from the LSB to the MSB.

3. The parity bit and stop bit are received. After receiving these bits, the SCI makes the following

checks:

a. Parity check: The number of 1s in the receive data must match the even or odd parity

setting of the O/

E bit in SCSMR.

b. Stop bit check: The stop bit value must be 1. If there are two stop bits, only the first stop bit

is checked.

c. Status check: RDRF must be 0 so that receive data can be loaded from SCRSR into

SCRDR.

If these checks all pass, the SCI sets RDRF to 1 and stores the received data in SCRDR. If
one of the checks fails (receive error), the SCI operates as indicated in table 14.12.

Note:

When a receive error flag is set, further receiving is disabled. The RDRF bit is not set to 1.
Be sure to clear the error flags.

4. After setting RDRF to 1, if the receive-data-full interrupt enable bit (RIE) is set to 1 in

SCSCR, the SCI requests a receive-data-full interrupt (RXI). If one of the error flags (ORER,
PER, or FER) is set to 1 and the receive-data-full interrupt enable bit (RIE) in SCSCR is also
set to 1, the SCI requests a receive-error interrupt (ERI).

Overrun error

ORER

Receiving of next data ends while
RDRF is still set to 1 in SCSSR

Receive data not
transferred from SCRSR
into SCRDR

Framing error

FER

Stop bit is 0

Receive data transferred
from SCRSR into SCRDR

Parity error

PER

Parity of receive data differs from
even/odd parity setting in SCSMR

Receive data transferred
from SCRSR into SCRDR