Peerless Industries SCS221 Manual Do Utilizador

ISSUED: 08-27-07  SHEET #: 083-9007-2   07-09-08

Visit the Peerless Web Site at www.peerlessmounts.com

For customer care call 1-800-865-2112 or 708-865-8870.

DRILL 5/32"

DIA. HOLES

DRILL 11/16" DIA.

HOLES

4"

(102 mm)

Wall plate (F) can be mounted to two studs that are 16" apart. Use a stud finder to locate the edges of the studs.
Use of an edge-to-edge stud finder is highly recommended. Based on their edges, draw a vertical line down each
stud’s center. Place wall plate on wall as a template. Level plate, and mark the center of the four mounting holes.
Make sure that the top two mounting holes are on the stud centerlines. Drill the top two mounting holes 5/32"
(4 mm) dia. by 2-1/2" (65 mm) deep.

Drill the bottom two holes 11/16" (17.5 mm) dia. as shown.

NOTE: Wall plate may be mounted up to 4" (102 mm) off center as shown.

2

• Installer must verify that the supporting surface will safely support the combined load of the equipment and all attached

hardware and components.

• Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the

screws, greatly reducing their holding power.

• Never tighten in excess of 80 in. • lb (9 N.M.).

• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud finder is

highly recommended.

• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Installers

are responsible to provide hardware for other types of mounting situations.