ONKYO TX-NR901 Manual Do Utilizador

3

Note to CATV system installer:
This reminder is provided to call the CATV system 
installer’s attention to Section 820-40 of the NEC which 
provides guidelines for proper grounding and, in partic-
ular, specifies that the cable ground shall be connected 
to the grounding system of the building, as close to the 
point of cable entry as practical.

The user changes or modifications not expressly 
approved by the party responsible for compliance could 
void the user’s authority to operate the equipment.

This equipment has been tested and found to comply 
with the limits for a Class B digital device, pursuant to 
Part 15 of the FCC Rules.
These limits are designed to provide reasonable protec-
tion against harmful interference in a residential instal-
lation. This equipment generates, uses and can radiate 
radio frequency energy and, if not installed and used in 
accordance with the instructions, may cause harmful 
interference to radio communications. However, there is 
no guarantee that interference will not occur in a partic-
ular installation.
If this equipment does cause harmful interference to 
radio or television reception, which can be determined 
by turning the equipment off and on, the user is encour-
aged to try to correct the interference by one or more of 
the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from 
that to which the receiver is connected.

•

Consult the dealer or an experienced radio/TV technician 
for help.

THIS CLASS B DIGITAL APPARATUS 

COMPLIES WITH CANADIAN ICES-003.

RSS-210, Low Power Licence-Exempt Radiocommuni-
cations Devices (All Frequency Bands)

For models having a power cord with a polarized plug:

TO PREVENT ELECTRIC SHOCK, 

MATCH WIDE BLADE OF PLUG TO WIDE SLOT, 
FULLY INSERT.

 CET APPAREIL NUMÉRIQUE DE 

LA CLASSE B EST CONFORME À LA NORME 
NMB-003 DU CANADA.

CNR-210. Dispositifs de radiocommunications de fai-
ble puissance, exempts de licence (pour toutes les ban-
des de fréquences)

Sur les modèles dont la fiche est polarisee:

 POUR ÉVITER LES CHOCS ÉLEC-

TRIQUES, INTRODUIRE LA LAME LA PLUS 
LARGE DE LA FICHE DANS LA BORNE CORRE-
SPONDANTE DE LA PRISE ET POUSSER 
JUSQU’AU FOND.

1. Recording Copyright—Unless it’s for personal use 

only, recording copyrighted material is illegal with-
out permission of the copyright holder.

2. AC Fuse— The AC fuse inside the TX-NR901 is 

not user-serviceable. If you cannot turn on the 
TX-NR901, contact your Onkyo dealer.

3. Care—Occasionally you should dust the 

TX-NR901 all over with a soft cloth. For stubborn 
stains, use a soft cloth dampened with a weak solu-
tion of mild detergent and water. Dry the 
TX-NR901 immediately afterwards with a clean 
cloth. Don’t use abrasive cloths, thinners, alcohol, 
or other chemical solvents, because they may dam-
age the finish or remove the panel lettering.

4. Power
WARNING
BEFORE PLUGGING IN THE UNIT FOR THE 
FIRST TIME, READ THE FOLLOWING SECTION 
CAREFULLY.
AC outlet voltages vary from country to country. Make 
sure that the voltage in your area meets the voltage 
requirements printed on the TX-NR901’s rear panel 
(e.g., AC 230 V, 50 Hz or AC 120 V, 60 Hz).
The Worldwide model has a voltage selector for com-
patibility with power systems around the world. Before 
you plug in this model, make sure that the voltage selec-
tor is set to the correct voltage for your area.

For American and Australian models
Setting the [STANDBY/ON] switch to STANDBY does 
not fully shutdown the TX-NR901. If you do not intend 
to use the TX-NR901 for an extended period, remove 
the power cord from the AC outlet.

1_Important_En Page 3 Thursday, October 2, 2003 2:42 PM