ONKYO TX-NR901 Manual Do Utilizador
48
Basic Setup
—Continued
Specifying the Location of an IR Receiver
This section explains how to specify the location when
using a commercially available IR receiver.
using a commercially available IR receiver.
Note:
• This procedure can also be performed by using the
TX-NR901’s [SETUP] button, [
]/[
]/[
]/[
]
buttons, and [ENTER] button.
Changing the TX-NR901’s Remote Control
ID
This section explains how to change the TX-NR901’s
remote control ID. You may need to change this if the
TX-NR901’s remote controller interferes with other
Onkyo components located in the same room.
remote control ID. You may need to change this if the
TX-NR901’s remote controller interferes with other
Onkyo components located in the same room.
Note:
If you change the TX-NR901’s remote control ID, be
sure to select the same ID on the remote controller
(page 49). The default ID for both the TX-NR901 and
remote controller is 1.
sure to select the same ID on the remote controller
(page 49). The default ID for both the TX-NR901 and
remote controller is 1.
Remote Setup
1
Press the scroll wheel, and then
press the [SETUP] button.
press the [SETUP] button.
The main menu appears onscreen.
2
Use the Up/Down [
]/[
] but-
tons to select “0. Hardware
Setup,” and then press the
[ENTER] button.
Setup,” and then press the
[ENTER] button.
The Hardware Setup menu appears.
3
Use the Up/Down [
]/[
] but-
tons to select “3. Remote Setup,”
and then press the [ENTER] but-
ton.
and then press the [ENTER] but-
ton.
The Remote Setup menu appears.
4
Use the Up/Down [
]/[
] but-
tons to select “a. Position,” and
then use the Left/Right [
then use the Left/Right [
]/[
]
buttons to select:
Main:
Select if the IR receiver is
located in the main room.
located in the main room.
Zone 2:
Select if the IR receiver is
located in, and will be used to
control Zone 2.
located in, and will be used to
control Zone 2.
5
Press the [SETUP] button.
The setup menu closes.
ENTER
ENTER
ENTER
ENTER
0-3.Remote Setup
a.Position :Main
b.Remote ID :1
b.Remote ID :1
Quit:[SETUP]
ENTER
1
Press the scroll wheel, and then
press the [SETUP] button.
press the [SETUP] button.
The main menu appears onscreen.
2
Use the Up/Down [
]/[
] but-
tons to select “0. Hardware
Setup,” and then press the
[ENTER] button.
Setup,” and then press the
[ENTER] button.
The Hardware Setup menu appears.
3
Use the Up/Down [
]/[
] but-
tons to select “3. Remote Setup,”
and then press the [ENTER] but-
ton.
and then press the [ENTER] but-
ton.
The Remote Setup menu appears.
4
Use the Up/Down [
]/[
] but-
tons to select “b. Remote ID,” and
then use the Left/Right [
then use the Left/Right [
]/[
]
buttons to select an ID: 1
(default), 2, or 3.
(default), 2, or 3.
ENTER
ENTER
ENTER
ENTER
ENTER
TX-NR901_En.book Page 48 Wednesday, October 1, 2003 9:44 AM