ONKYO TX-NR1000 Manual Do Utilizador

128

Tape mode is used to control an Onkyo cassette 
recorder connected to the TX-NR1000/TX-NR5000E 

via . 

placing your remote controller into “AMP” mode.

Note:
While neither the [INPUT] button nor [MODE] button 
is illuminated, rolling the scroll wheel changes the input 
source and remote controller mode simultaneously 
(when you select “TAPE1” as the top line, “AMP” 
appears in the bottom line).

1

This button is used with the scroll wheel to select 
the remote controller modes. Press the scroll wheel 
until “AMP” appears on the display.

2

The Previous [

] button is used to select the pre-

vious track. During playback it selects the begin-
ning of the current track. The Next [

] button is 

used to select the next track. 
The Previous/Next [

]/[

] buttons may not 

work properly with some cassette tapes depending 
on how they were recorded.

3

The Rewind [

] button is used to start rewind. 

The FF [

] button is used to start fast forward.

4

●

 

This button is used to start tape recording.

5

This button is used to turn on or off the remote con-
troller’s illuminated buttons.

6

This button is used to select the input source. Press 
this button first, and then roll the scroll wheel until 
“TAPE1” appears on the display.

7

This button is used to set the volume of the 
TX-NR1000/TX-NR5000E.

8

This button is used to mute the TX-NR1000/
TX-NR5000E. This function can be set only with 
the remote controller.

8

This button is used to start tape playback.

0

This button is used to stop tape playback.

A

This button is used to start reverse playback.

+

-

+

-

I