ONKYO TX-NR1000 Manual Do Utilizador
142
Other Settings for the Remote Controller
—Continued
This section explains how to change the remote control-
ler’s ID. You may need to change this if the
TX-NR1000/TX-NR5000E’s remote controller inter-
feres with other Onkyo components located in the same
room.
ler’s ID. You may need to change this if the
TX-NR1000/TX-NR5000E’s remote controller inter-
feres with other Onkyo components located in the same
room.
Note:
If you change the remote controller’s ID, be sure to
select the same ID on the TX-NR1000/TX-NR5000E.
For details on setting up the TX-NR1000/
TX-NR5000E’s remote control ID, refer to the “Remote
Control Setup Sub-menu” section on page 87. The
default ID for both the TX-NR1000/TX-NR5000E and
remote controller is 1.
If you change the remote controller’s ID, be sure to
select the same ID on the TX-NR1000/TX-NR5000E.
For details on setting up the TX-NR1000/
TX-NR5000E’s remote control ID, refer to the “Remote
Control Setup Sub-menu” section on page 87. The
default ID for both the TX-NR1000/TX-NR5000E and
remote controller is 1.
Changing the Remote Controller’s
Control ID
Control ID
1
Hold down the remote controller’s [CUS-
TOM] button for more than three seconds.
TOM] button for more than three seconds.
The remote controller enters Custom mode.
2
Roll the scroll wheel to select “SETUP”
menu, and then press the scroll wheel.
menu, and then press the scroll wheel.
3
Roll the scroll wheel to select ID menu,
and then press the scroll wheel.
and then press the scroll wheel.
4
Roll the scroll wheel to select an
ID—1 (default), 2, or 3—and then
press the scroll wheel.
ID—1 (default), 2, or 3—and then
press the scroll wheel.
Select the same ID as that set on the
TX-NR1000/TX-NR5000E.
TX-NR1000/TX-NR5000E.