ONKYO DR-90 Manual Do Utilizador

8

1

2

Insert the two R6 (size AA) batteries.
Be sure to match the + and – ends of the batteries with
the diagram inside the battery compartment.

3

Some buttons on the remote controller have two
functions. The DVD RECEIVER/LEVEL SETUP/TV
switch changes these functions as follows.

• When the batteries are getting weak, the

SENDING/LEARNED indicator on the
remote controller starts flashing. In this
case, replace the batteries with new ones.
For the other functions of this indicator, see
“Pointing the remote controller in the right
direction” on the right, and page 60.

• Do not mix new batteries with old batteries

or different kinds of batteries.

• To avoid corrosion, remove the batteries if

the remote controller is not to be used for a
long time.

• Remove dead batteries immediately to avoid damage from

corrosion. If the remote controller does not operate smoothly,
replace both the batteries at the same time.

• The life of the batteries supplied is about six months but this will

vary depending on usage.

Point the remote controller toward the remote control
sensor.

• Place the unit away from strong light such as direct sunlight or

inverted fluorescent light which can prevent proper operation of the
remote controller.

• Using another remote controller of the same type in the same room

or using the unit near equipment which uses infrared rays may
cause operational interference.

• Do not put any object such as a book on the remote controller. The

buttons of the remote controller may be pressed by mistake and
drain the batteries.

• Make sure the audio rack doors do not have colored glass. Placing

the unit behind such doors may prevent proper remote controller
operation.

• If there is any obstacle between the remote controller and the

remote control sensor, the remote controller will not operate.

Set the switch to LEVEL SETUP when adjusting each
speaker’s relative volume balance.
See pages 19 and 32.

Set the switch to TV when you wish to control your TV.
Before you start using this function, you need to copy
the signal patterns of the TV’s remote control buttons to
the DVD Receiver’s remote controller. See page 60.

1

2

3

SENDING/
LEARNED indicator

The STANDBY indicator lights up when the DVD
Receiver receives a signal from the remote
controller. For the other functions of this indicator,
see page 17.

This indicator is lit
while any button
on the remote
controller is
pressed.

SENDING/
LEARNED
indicator

Remote control sensor

Normally set the switch to DVD
RECEIVER.
Most of the operations can be used
when the switch is set to this position.

REMOTE CONTROLLER                                               

RC-399M