Yamaha YSP-4100BL Manual Do Utilizador

Página de 58
15
 En
PREP
ARA
TION
IN
T
R
ODU
C
TI
ON
AP
PEN
DI
X
PLA
Y
B
A
CK FEA
T
URES
Changing OSD 
language
AUTO SETUP 
(IntelliBeam)
Using the system 
memory
S
E
TT
INGS
You can select an OSD language among English, German, French, Spanish, Italian, Dutch and Russian. Before operating 
the following steps, select this unit as the video input on your TV.
1
Press and hold ISETUP until the 
“LANGUAGE SETUP” menu appears on your 
TV.
2
Press G
 / 
 to select the desired 
language and then press GENTER.
Choices: ENGLISH (English), DEUTSCH (German), 
Français (French), ESPAÑOL (Spanish), 
ITALIANO (Italian), NEDERLANDS (Dutch), 
Русский (Russian)
Initial setting: ENGLISH (English)
3
To exit from the menu, press ISETUP.
This unit creates a sound field by reflecting sound beams off the walls of your listening room and by broadening the 
cohesion of all the channels. Just as you would arrange the speaker position of other audio systems, you need to set the 
beam angle to enjoy the best possible sound from this unit.
Notes
• After you have completed the AUTO SETUP procedure, be sure to disconnect the IntelliBeam microphone.
• The IntelliBeam microphone is sensitive to heat.
– Keep the IntelliBeam microphone away from direct sunlight.
– Do not place the IntelliBeam microphone on top of this unit.
• You cannot use the AUTO SETUP when “PREOUT” is selected in “SOUND OUT” (page 38).
• You cannot run the AUTO SETUP while playing back the iPod/iPhone by using PDX-50TX. To run the AUTO SETUP, stop playback 
and then disconnect the iPod/iPhone from PDX-50TX. About PDX-50TX, refer to “Safety and Accessory Information” (separate 
booklet).
Follow the procedure below to connect the IntelliBeam 
microphone to this unit and place it in a proper location.
1
Connect the supplied IntelliBeam 
microphone to the INTELLIBEAM MIC jack on 
the front panel.
2
Place the IntelliBeam microphone on a flat 
level surface at your normal listening 
position.
Place the IntelliBeam microphone on the extended 
center line of this unit and 1.8 m (6.0 ft) or more 
away from it. Also, make sure place the IntelliBeam 
microphone within 1 m (3.3 ft) upper or lower from 
the center height of this unit.
y
• Use the supplied cardboard microphone stand or a tripod 
to place the IntelliBeam microphone at the same height as 
your ears would be when you are seated.
Changing OSD language
ENGLISH
DEUTSCH
Francais
ESPANOL
ITALIANO
NEDERLANDS
[ ]/[ ]:Up/Down
[ENTER]:Enter
3)LANGUAGE SETUP
p
p
.
AUTO SETUP (IntelliBeam)
Installing the IntelliBeam 
microphone
INPUT
VOLUME
INTELLIBEAM MIC
INTELLIBEAM MIC
IntelliBeam microphone
1.8 m (6.0 ft)
or more
Within 1 m (3.3 ft)
Cardboard 
microphone stand
Listening 
position
Upper limit
Lower limit
Center height of 
this unit
Within 1 m (3.3 ft)
IntelliBeam 
microphone
Cardboard
microphone
stand
Center line