Yamaha YSP-4100BL Manual Do Utilizador

Press ISETUP.

Press G 

and then press GENTER.

y

• To return to the previous menu, press IRETURN.

Press G 

 /   /   and GENTER to 

y

• The initial settings are marked with “*”.

• The menu screen disappears if one of the DInput selector 

keys is pressed while the SET MENU is being configured. 

To exit from the menu, press ISETUP.

Use this menu to manually adjust the parameters related to 
the sound beam output. To fine-adjust parameters 
configured by AUTO SETUP, use “BEAM 
ADJUSTMENT” and “IMAGE LOCATION”.

■ SETTING PARAMETERS (Setting 

→ MANUAL SETUP → SETTING 

PARAMETERS
Use to set the position of this unit in your listening room 
and the distance of this unit from the listening position.

y

• If you make adjustments in “SETTING PARAMETERS”, the 

“BEAM ADJUSTMENT” parameters are automatically 
adjusted.

• If you make adjustments in “SETTING PARAMETERS”, the 

beam optimization settings made in the AUTO SETUP 
procedure will be lost.

In “SETTING PARAMETERS 1/3”, configure 
“INSTALLED POSITION”.
Select the installed position of this unit.
Choices: FLAT TO WALL* (parallel to wall), 
ANGLE TO WALL OR CORNER (angle to wall or 
corner)

• If you change this setting, “BEAM MODE” setting 

changes automatically (page 23).

Configure “INSTALLED HEIGHT”.
Specify the installed height of this unit.
Control range: 0.0 m to 3.0 m (0.0 ft to 10.0 ft)
Initial setting: 1.0 m (3.5 ft)

y

• Press G 

 to proceed to the next page.

In “SETTING PARAMETERS 2/3”, configure 
the listening room settings.
Specify the length and width of the listening room.
Control range: 2.0 m to 12.0 m (6.5 ft to 40.0 ft)

In “SETTING PARAMETERS 3/3”, configure 
the distance settings.
Specify the distance between the listening position 
and this unit. When this unit is installed parallel to 
wall, you also need to specify the distance between 
the listening position and left wall.

;MEMORY

;AUTO SETUP

;MANUAL SETUP

;SOUND SET MENU

;SOUND OUT MENU

;INPUT MENU

;DISPLAY MENU

[ ]/[ ]:Up/Down
[ENTER]:Enter

SET MENU

.

p

p

1)SETTING PARAMETERS
2)BEAM ADJUSTMENT
3)IMAGE LOCATION

[ ]/[ ]:Up/Down
[ENTER]:Enter

C)MANUAL SETUP

p

p

.

DInput selector keys

GENTER

G 

 / 

 /   / 

G  

/ 

G 

IRETURN

ISETUP

I

G

D