Yamaha ATS-1010BL Manual Do Utilizador
Additional Information
10
En
3
Press the button below of the main unit to
select the operation you want the unit to
learn.
select the operation you want the unit to
learn.
4
Point your TV remote control at the
remote control sensor and press the
respective button twice or three times
until the indicator changes from flashing
green to lit green.
remote control sensor and press the
respective button twice or three times
until the indicator changes from flashing
green to lit green.
Fault in learning
The UNIVOLUME, CLEAR VOICE and
SURROUND indicators flash in green
simultaneously for about 3 seconds.
The UNIVOLUME, CLEAR VOICE and
SURROUND indicators flash in green
simultaneously for about 3 seconds.
5
Repeat steps 3 and 4 to make the unit
learn the other operations.
learn the other operations.
6
Press the
button of the main unit for
more than 3 seconds to finish the remote
control learning mode.
control learning mode.
Release the
button of the main unit when all the
indicators light up in green. The unit enters standby
mode.
mode.
• The unit will automatically set to standby mode if the unit
in the remote control learning mode is left turned on for 5
minutes without any operation being performed.
minutes without any operation being performed.
• If learning fails, try again with your TV turned off. Note
that screen glare may disturb TV remote control learning.
1
Set the unit to standby mode.
2
Press both the INPUT
button and
button and
button of the
main unit, release the
button first, then release the
INPUT button.
INPUT button.
3
Press the INPUT button of the main unit
again for more than 3 seconds.
again for more than 3 seconds.
4
Release the INPUT button of the main unit
when qD DTS indicator flashes.
when qD DTS indicator flashes.
Press the
button of the main unit for more than 3
seconds to finish the remote control learning mode, or
to have the unit learn operations of another TV
remote control.
to have the unit learn operations of another TV
remote control.
Should the unit freeze for any reason, this may be
remedied by initiating the factory settings.
remedied by initiating the factory settings.
1
Set the unit to standby mode.
2
Press and hold the
button of the main
unit for more than 3 seconds.
All the indicator flashes in green.
3
Release the
button of the main unit.
Operation you
want the unit to
learn
The button
of the unit
The Indicator
flashes in green
Volume down
VOLUME –
Volume up
VOLUME +
Power on/standby
mode
mode
Press
(1 sec)
(1 sec)
Release
(1 sec)
(1 sec)
Press
(1 sec)
(1 sec)
Flashes
rapidly
rapidly
Indicator
Approx.
30 cm
(1 ft)
30 cm
(1 ft)
Flashes
Flashes
rapidly
rapidly
Success in learning
e.g.
Volume up
Volume up
Notes
Removing all learned TV remote
control operations
control operations
Resetting the unit
Flashes in
red