ONKYO SKC-230C Manual Do Utilizador

 

5

 

A

 

To turn on the SKW-150X, set the POWER switch 
to the ON position (the indicator lights up).
To turn off the SKW-150X, set the POWER switch 
to the OFF position (the indicator goes out).

Red:

 The unit is in standby mode

Green:  The unit is in operation mode

The SKW-150X automatically turns to Standby 
mode when no signal has been input for about 20 
minutes. The SKW-150X automatically turns on 
when an input signal is detected in Standby mode.

 

B

 

This control is used to adjust the output level of the 
subwoofer.

 

C

 

The RCA input should be connected to the sub-
woofer preout on your AV receiver, amp, or other 
receiver with supplied RCA cable.

 

The Auto Standby function turns the subwoofer on when 
the input signal exceeds a certain level. If the Auto 
Standby function does not work reliably, try slightly 
increasing or decreasing the subwoofer output level on 
your receiver or amp.

 

1

 

These push terminals are for connecting the speaker 
to your DVD Receiver, amp, or other receiver with 
the supplied speaker cables. The supplied speaker 
cables are color-coded for easy identification. Sim-
ply connect each cable to the same-colored positive 
speaker terminal.

 

2

 

These keyhole slots can be used to wall-mount the 
speaker either horizontally or vertically.

 

3

 

These threaded inserts can be used to attach the 
speaker either horizontally or vertically to a speaker 
mount or bracket.

 

Use commercially available M5 screws to attach the 
speaker to a speaker mount or bracket.

 

4

 

These threaded inserts can be used to mount the 
speaker on the supplied base (screws included).

2

3

1

■ Front

■ Rear

To AC outlet

2

1

3

4

SKS-HT230_En.fm Page 5 Friday, January 16, 2004 4:54 PM