Genesis Advanced Technologies G5.3 Manual Do Utilizador

Página de 22
 
 
ver 1.0 
 
11
11
11
11
~ÄëçäìíÉ=ÑáÇÉäáíó
music. When these speakers are properly set up, you will have a 
sweet spot wide enough for you and your spouse. When you sway 
side to side while enjoying the music, the image and tonality of the 
system should also not waver. 
When properly set up very little sound should appear to come 
directly from the speaker, instead, the sound stage should extend 
far beyond the left and right edge of the loudspeakers and they 
should have tremendous front to back depth. When the recording is 
close miked (when the instrument or performer is very close to the 
recording microphone) the music may appear to come directly 
from the loudspeaker. This is normal. Typically, however, the sound 
should appear to be detached from the loudspeakers. 
A simple rule of thumb to follow is that focus will be achieved by 
placing the speakers closer together or farther apart, and front to 
back depth can be adjusted by the distance from the rear wall. 
Further, as the system “breaks in”, the depth and width of the 
soundstage will increase and so will the “smoothness” of the sound. 
Tuning into the room 
There are no absolute rules concerning the speaker/room 
coupling, so do not be afraid to experiment with speaker 
placement for best results. Positioning the speakers within the 
room will significantly affect the quality of the bass. This is 
because of standing waves caused by bass modes in the room. 
Hence, you should experiment with asymmetric positioning in the 
room. Do not have your speakers the same distance from the side 
and front walls – try putting them closer to the left or the right wall. 
If the speakers are equidistance from side and front wall, you may 
find strange suck-outs at some frequencies. 
In some problematic rooms a resonance may develop at one or 
two frequencies that is unnatural to the music. By moving the 
speakers closer to the front/side wall or farther 
from the front/side 
wall, the resonance may be reduced at the listener’s position. 
The amount of hard and soft surfaces in your room will also affect 
the tonal balance of your loudspeakers. For example, with lots of 
very hard surfaces such as marble or granite floors, large picture 
windows, and concrete walls, you may find that the room is very