Bluetrek X2 Manual Do Utilizador

PAGE 4 / 6 

To initiate pairing: 
 

1.   Place the BLUETREK® X2 and your mobile phone within 0.3 meter (1 foot) from 

each other.  

2.  Switch on your phone and select its Bluetooth® discover mode (refer to the 

Bluetooth® mobile phone user manual). 

3.  When the BLUETREK® X2 is switched off, press and hold the TALK button for 

about 7 seconds until the indicator light flashes red and blue alternately.  And a 
sound can be heard in the speaker. 

4.  Once the mobile phone detects the headset, a “BLUETREK X2” message will be 

displayed. Follow the phone instructions to accept the pairing. The PIN code (or 
passkey) is 0000, then press “yes” or “ok”. 

 

If pairing success, the indicator light will switch to blue and flashes slowly. 

 

If you haven’t started the discovery mode within 5 minutes, the headset will switch off. 
You must then switch on your headset and start the pairing again. 
 

For your convenience, the ear loops and the ear hook of BLUETREK® X2 are designed 
to be removable and can be worn on either ear.  BLUETREK®X2, as packaged, is 
already with the small ear loop that is specially designed for active outdoor use. 

 

To replace with the ear hook: 
Simply unsnap the ear loop from the headset by pulling gently at the base of the ear 
clamp ring. 
 
Snap the ear hook onto the headset by applying gentle pressure on the base of the ear 
clamp ring. 

 

The ear hook is made of a soft material which can be shaped to fit your ear. Please refer 
to the above diagram of how it can be adjusted. 

 
Switching BLUETREK® X2 ON 
When your headset is off, press and hold the TALK button for about 2 seconds until the 
blue indicator light is on. A beep (2 tones) can be heard in the speaker. Release the 
TALK Button. 
 
To check if your headset is ON, press once on the TALK button. If the indicator light 
flashes blue, it means your headset is ON. 

When your headset is on, press and hold the TALK button for about 5 seconds until the 
red indicator light is on after the quick blue flashes. A beep (2 tones) can be heard in the 
speaker then release the TALK Button.