Kenwood RC-2000 Manual Do Utilizador

38

To access your desired DX information from the P.C.T
memory in the P.C.T. mode:

1 Press [LIST] (L2).

2 Press [

c

]/ [

d

] or turn the MULTI/ CH control to

select the report.

•

“

s

” indicates which DX report is currently

selected.

3 Press [SET] to tune the main transceiver to the

reported frequency.

•

Press [DEL] to erase the selected DX information
from the P.C.T. memory.  Press [EXIT] to return to
normal P.C.T. information display.

•

Press [OK] to view all the comments of the
selected DX station.

The transceiver can be set to output a beep instead of a
Morse code when new DX Packet Cluster data is
received.  Press [MENU] while in group A–3, then turn
the MULTI/ CH control to select Menu No. 49.  Press
[SUB], then turn the MULTI/ CH control to access Menu
No. 49B.  Select “OFF”.  “VOICE” can also be set when
you install the optional VS-3 {TS-2000 page 91}.

◆

You cannot send DX information to a node using the P.C.T. mode.

◆

The DX Packet Cluster data in memory is retained when the
transceiver is turned OFF.  However, the sub-receiver’s frequency
display returns to the receiving frequency of the DX Packet Cluster
node.