Kenwood RC-2000 Manual Do Utilizador

45

You must also program the CTCSS tone to operate the
Sky Command II+.  Select the same CTCSS tone for
both the Commander and the Transporter.

1 Press [F1] (1 s) until you select group A.

2 Press [F1] until you select A–3.

3 Press [MENU].

4 Turn the MULTI/ CH control to select Menu No. 62.

5 Press [SUB].

6 Turn the MULTI/ CH control to select Menu No. 62C.

7 Press [–]/ [+]  to select a CTCSS tone frequency for

the Sky Command II+ operation.

8 Press [OK] to store the CTCSS tone frequency for

the Sky Command II+ operation.  Press [CLR] to
cancel the selection.

You must configure the same TNC communication speed
between the Commander and the Transporter.

1 Press [F1] (1 s) until you select group A.

2 Press [F1] until you select A–3.

3 Press [MENU].

4 Turn the MULTI/ CH control to select Menu No. 62.

5 Press [SUB].

6 Turn the MULTI/ CH control to select Menu No. 62D.

7 Press [–]/ [+]  to select either 1200 bps or 9600 bps.

8 Press [OK] to store the TNC communication speed

for the Sky Command II+ operation.  Press [CLR] to
cancel the selection.

Note:  9600 bps can be used only when you use TS-2000(X)/ TS-B2000
for both the Commander and the Transporter.

If you are using a TS-2000(X)/ TS-B2000, confirm that
the built-in TNC is assigned to the sub-receiver.

1 Press [F1] (1 s) until you select group A.

2 Press [F1] until you select A–3.

3 Press [MENU].

4 Turn the MULTI/ CH control to select Menu No. 46.

5 Press [–]/ [+]  to select “SUB”.

6 Press [OK] to store the TNC band for the Sky

Command II+ operation.  Press [CLR] to cancel the
selection.