Kenwood TK-8360 Manual Do Utilizador

2

n

For passenger safety, install the transceiver securely using the supplied mounting bracket and 

screw set, so the transceiver will not break loose in the event of a collision.

:  Before installing the transceiver, check how far the mounting screws will extend below 

the surface.  When drilling mounting holes, be careful not to damage vehicle wiring or parts.

  Mark the position of the holes in the dash, using the mounting bracket as a 

template.  Using a 4.2 mm (5/32 inch) drill bit, drill the holes, then attach the 

mounting bracket using the supplied screws.

•  Mount the transceiver within easy reach of the user and where there is sufficient 

space at the rear of the transceiver for cable connections.

  Connect the antenna and the supplied power cable to the transceiver.

  Slide the transceiver into the mounting bracket and secure it using the 

supplied hex-headed screws.

  Mount the optional microphone hanger in a location where it will be within 

easy reach of the user.

•  The microphone and microphone cable should be mounted in a place where they 

will not interfere with the safe operation of the vehicle.

When replacing the fuse in the DC power cable, be sure to replace it with a fuse of the same 

value.  Never replace a fuse with one that is rated with a higher value.

M4 x 6 mm  

Hex-headed screw

DC power cable

Mounting bracket

Antenna 

connector

Power input 

connector

Fuse

Black (–) cable

Red (+) cable

2 V vehicle 

battery

Optional

Microphone

5 x 6 mm

Self-tapping screw

Spring 

washer

Flat 

washer