Kenwood TM-D700A Manual Do Utilizador

3

■

1 Assemble the mounting brackets using the

supplied 2 hexagon SEMS screws and 2 flat
washers.

• Do not completely tighten the screws in this step.

2 Peel off the paper backing from the rear of the

bracket.

3 Position the bracket in the vehicle, then install it

securely using the supplied 3 self-tapping screws
and 3 flat washers.

4 Position the grooves on the front panel over the

bracket tabs.

5 Slide the front panel down until its locking tab

clicks.

•

The tab on the front panel must be completely locked
by the bracket; otherwise vehicle vibration may
cause the front panel to drop off the bracket.

6 Determine the angle of the front panel, then

completely tighten the 2 SEMS screws on the
bracket.

SEMS screw

Self-tapping screw
(4 mm x 14 mm)

Flat washer

Bracket tab

Locking tab

SEMS screw