Kenwood KDC-HD455U Manual Do Utilizador

Página de 40
2
CONTENTS
BEFORE USE
 Warning
  Do not operate any function that takes your attention away from safe driving.
 Caution
  Volume setting:
•  Adjust the volume so that you can hear sounds outside the car to prevent accident.
•  Lower the volume before playing digital sources to avoid damaging the speakers by the sudden increase of the 
output level.
  General:
•  Avoid using the USB device or iPod/iPhone if it might hinder driving safety. 
•  Make sure all important data has been backed up. We shall bear no responsibility for any loss of recorded data.
•  Never put or leave any metallic objects (such as coins or metal tools) inside the unit, to prevent a short circuit.
•  If a disc error occurs due to condensation on the laser lens, eject the disc and wait for the moisture to evaporate.
  Remote control (RC-406):
•  Do not leave the remote control in hot places such as on the dashboard.
•  The Lithium battery is in danger of explosion if replaced incorrectly. Replace it only with the same or equivalent 
type.
•  The battery pack or batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
•  Keep battery out of reach of children and in original package until ready to use. Dispose of used batteries 
promptly. If swallowed, contact a physician immediately.
  CALIFORNIA, USA ONLY
  This perchlorate WARNING applies only to the product sold or distributed in California USA “Perchlorate 
Material–special handling may apply, See www.dtsc.ca.gov/hazardouswaste/perchlorate.”
2
BEFORE USE 
2
BASICS 
3
GETTING STARTED 
4
CD / USB / iPod 
5
AUX 
6
HD RADIO™ 
7
Pandora® 
8
AUDIO SETTINGS 
9
DISPLAY SETTINGS 
10
MORE INFORMATION 
10
TROUBLESHOOTING 
11
INSTALLATION / CONNECTION 
12
SPECIFICATIONS 
i and ii 
 
(at the end of the book)
How to read this manual
•  Operations explained mainly using buttons 
on the faceplate.
•  [XX] indicates the selected items.
•  ( XX) indicates references are available on 
the stated page number.
Maintenance
Cleaning the unit: Wipe off dirt on the faceplate with a dry silicon or soft cloth.
Cleaning the connector: Detach the faceplate and clean the connector with a 
cotton swab gently, being careful not to damage the connector.
Handling discs:
•  Do not touch the recording surface of the disc.
•  Do not stick tape etc. on the disc, or use a disc with tape stuck on it.
•  Do not use any accessories for the disc.
•  Clean from the center of the disc and move outward.
•  Clean the disc with a dry silicon or soft cloth. Do not use any solvents.
•  When removing discs from this unit, pull them out horizontally.
•  Remove burrs from the center hole and disc edge before inserting a disc.
Connector (on the reverse 
side of the faceplate)
EN_KDC-X497[KW]_f.indd   2
EN_KDC-X497[KW]_f.indd   2
10/1/12   11:04:23 AM
10/1/12   11:04:23 AM